AD8676BRZ Analog Devices Inc, AD8676BRZ Datasheet - Page 5

• Manufacturer Part Number: AD8676BRZ
• Description: IC OPAMP GP R-R 10MHZ DUAL 8SOIC
• Manufacturer: Analog Devices Inc

Specifications of AD8676BRZ

• Slew Rate: 2.5 V/µs
• Design Resources: Logarithmic Audio Volume Control with Glitch Reduction Using AD5292 (CN0120) 18-Bit Accurate, low noise, precision bipolar DC voltage source (CN0177)
• Amplifier Type: General Purpose
• Number Of Circuits: 2
• Output Type: Rail-to-Rail
• Gain Bandwidth Product: 10MHz
• Current - Input Bias: 2nA
• Voltage - Input Offset: 12µV
• Current - Supply: 2.7mA
• Current - Output / Channel: 20mA
• Voltage - Supply, Single/dual (±): 10 V ~ 36 V, ±5 V ~ 18 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Op Amp Type: Precision
• No. Of Amplifiers: 1
• Bandwidth: 10MHz
• Supply Voltage Range: ± 5V To ± 18V
• Amplifier Case Style: SOIC
• No. Of Pins: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• -3db Bandwidth: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

ABSOLUTE MAXIMUM RATINGS
Table 4.
Parameter
Supply Voltage
Input Voltage
Differential Input Voltage
Output Short-Circuit Duration to GND
Storage Temperature Range
Operating Temperature Range
Junction Temperature Range
Lead Temperature Range (Soldering, 10 sec)
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
RM, R Packages
RM, R Packages
Rating
±18 V
±V supply
±0.7 V
Indefinite
−65°C to +150°C
−40°C to +125°C
−65°C to +150°C
300°C
Rev. B | Page 5 of 12
THERMAL RESISTANCE
Table 5. Thermal Resistance
Package Type
8-Lead MSOP (RM)
8-Lead SOIC_N (R)
POWER SEQUENCING
The op amp supplies must be established simultaneously with,
or before, any input signals are applied. If this is not possible,
the input current must be limited to 10 mA.
ESD CAUTION
θ
210
158
JA
θ
45
43
JC
AD8676
Unit
°C/W
°C/W