EL5427CRZ Intersil, EL5427CRZ Datasheet - Page 13
![IC BUFFER RR 2.5MHZ 12CH 28TSSOP](/photos/12/54/125415/el5427crz_sml.jpg)
EL5427CRZ
Manufacturer Part Number
EL5427CRZ
Description
IC BUFFER RR 2.5MHZ 12CH 28TSSOP
Manufacturer
Intersil
Datasheet
1.EL5227CRZ.pdf
(17 pages)
Specifications of EL5427CRZ
Amplifier Type
Buffer
Number Of Circuits
12
Output Type
Rail-to-Rail
Slew Rate
2.2 V/µs
-3db Bandwidth
2.5MHz
Current - Input Bias
2nA
Voltage - Input Offset
1000µV
Current - Supply
1.6mA
Current - Output / Channel
120mA
Voltage - Supply, Single/dual (±)
4.5 V ~ 16.5 V, ±2.25 V ~ 8.25 V
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
28-TSSOP
Rohs Compliant
YES
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Gain Bandwidth Product
-
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
EL5427CRZ
Manufacturer:
CTS
Quantity:
10 000
Part Number:
EL5427CRZ
Manufacturer:
INTERSIL
Quantity:
20 000
EL5127, EL5227, EL5327, EL5427
Driving Capacitive Loads
The EL5127, EL5227, EL5327, and EL5427 can drive a wide
range of capacitive loads. As load capacitance increases,
however, the -3dB bandwidth of the device will decrease and
the peaking increase. The buffers drive 10pF loads in
parallel with 10kΩ with just 1.5dB of peaking, and 100pF
with 6.4dB of peaking. If less peaking is desired in these
applications, a small series resistor (usually between 5Ω and
50Ω) can be placed in series with the output. However, this
will obviously reduce the gain slightly. Another method of
reducing peaking is to add a “snubber” circuit at the output.
A snubber is a shunt load consisting of a resistor in series
with a capacitor. Values of 150Ω and 10nF are typical. The
advantage of a snubber is that it does not draw any DC load
current or reduce the gain.
Power Supply Bypassing and Printed Circuit
Board Layout
As with any high frequency device, good printed circuit
board layout is necessary for optimum performance. Ground
plane construction is highly recommended, lead lengths
should be as short as possible, and the power supply pins
must be well bypassed to reduce the risk of oscillation. For
normal single supply operation, where the V
- pin is
S
connected to ground, a 0.1µF ceramic capacitor should be
placed from V
+ pin to V
- pin. A 4.7µF tantalum capacitor
S
S
should then be connected from V
+ pin to ground. One
S
4.7µF capacitor may be used for multiple devices. This same
capacitor combination should be placed at each supply pin
to ground if split supplies are to be used.
13
FN7111.4
May 4, 2007