EL5427CRZ-T13 Intersil, EL5427CRZ-T13 Datasheet - Page 13

• Manufacturer Part Number: EL5427CRZ-T13
• Description: IC BUFFER LP 12CH 2.5MHZ 28TSSOP
• Manufacturer: Intersil

Specifications of EL5427CRZ-T13

• Amplifier Type: Buffer
• Number Of Circuits: 12
• Output Type: Rail-to-Rail
• Slew Rate: 2.2 V/µs
• -3db Bandwidth: 2.5MHz
• Current - Input Bias: 2nA
• Voltage - Input Offset: 1000µV
• Current - Supply: 1.6mA
• Current - Output / Channel: 120mA
• Voltage - Supply, Single/dual (±): 4.5 V ~ 16.5 V, ±2.25 V ~ 8.25 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-TSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Gain Bandwidth Product: -

EL5127, EL5227, EL5327, EL5427
Driving Capacitive Loads
The EL5127, EL5227, EL5327, and EL5427 can drive a wide
range of capacitive loads. As load capacitance increases,
however, the -3dB bandwidth of the device will decrease and
the peaking increase. The buffers drive 10pF loads in
parallel with 10kΩ with just 1.5dB of peaking, and 100pF
with 6.4dB of peaking. If less peaking is desired in these
applications, a small series resistor (usually between 5Ω and
50Ω) can be placed in series with the output. However, this
will obviously reduce the gain slightly. Another method of
reducing peaking is to add a “snubber” circuit at the output.
A snubber is a shunt load consisting of a resistor in series
with a capacitor. Values of 150Ω and 10nF are typical. The
advantage of a snubber is that it does not draw any DC load
current or reduce the gain.
Power Supply Bypassing and Printed Circuit
Board Layout
As with any high frequency device, good printed circuit
board layout is necessary for optimum performance. Ground
plane construction is highly recommended, lead lengths
should be as short as possible, and the power supply pins
must be well bypassed to reduce the risk of oscillation. For
normal single supply operation, where the V
- pin is
S
connected to ground, a 0.1µF ceramic capacitor should be
placed from V
+ pin to V
- pin. A 4.7µF tantalum capacitor
S
S
should then be connected from V
+ pin to ground. One
S
4.7µF capacitor may be used for multiple devices. This same
capacitor combination should be placed at each supply pin
to ground if split supplies are to be used.
13
FN7111.4
May 4, 2007