AT88SC25616C-DK Atmel, AT88SC25616C-DK Datasheet - Page 27

• Manufacturer Part Number: AT88SC25616C-DK
• Description: KIT DEV CRYPTOMEMORY SMARTCARD
• Manufacturer: Atmel
• Series: CryptoMemory®r
• Type: Crypto and Secure Memoryr

Specifications of AT88SC25616C-DK

• Contents: PC/SC Card Reader, Sample Cards, API, Documentation and Tutorial
• For Use With/related Products: AT88SC Family
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: AT88SC25616CDK; AT88SC25616CDK

7. Synchronous Protocol
7.1
7.2
24
Start-up Sequence
Command Set
AT88SC0104/0204/0404/0808/1616/3216/6416/12816/25616C
Communication with the CryptoMemory using the synchronous protocol is very similar to com-
munication with AT24Cxxx Serial EEPROM devices using a two-wire protocol (TWI). Basic
command structure and timing are the same however a significant difference exists when read-
ing the CryptoMemory device that will be described below.
When first powering up the device, 5 pulses are required on CLK-SCL for reading of internal reg-
isters. This may be accomplished by sending one full command byte to the device. The device
will not respond but will then be ready to respond to the next correct command sequence.
The command set of CryptoMemory is expanded compared to a Serial EEPROM as the func-
tionality of CryptoMemory exceeds that of a simple memory device. Each instruction sent to the
CryptoMemory must have 4 bytes: Command, Address 1, Address 2 and N. The last byte, N,
defines the number of any additional data bytes to be sent or received from the CryptoMemory
device.
• Power-up V
• External pull-up resistor pulls I/O-SDA high with V
• After stable V
• CLK-SCL and I/O-SDA may be driven.
CLK-SCL
I/O-SDA
V cc
CC
CC
, 5 pulses are applied to CLK-SCL
1
2
3
4
CC
5
5210B–SMIC–11/08