ACPM-7813-BLK Avago Technologies US Inc., ACPM-7813-BLK Datasheet - Page 11

• Manufacturer Part Number: ACPM-7813-BLK
• Description: IC PA MOD UMTS BAND4/9 10-SMD
• Manufacturer: Avago Technologies US Inc.
• Type: Power Amplifierr

Specifications of ACPM-7813-BLK

• Current - Supply: 520mA
• Frequency: 824MHz ~ 849MHz
• Gain: 28.5dB
• Noise Figure: 4.5dB
• Package / Case: 10-SMD Module
• Rf Type: UMTS
• Voltage - Supply: 3.2V ~ 4.2V
• Operating Frequency: 849 MHz
• Supply Current: 520 mA
• Maximum Power Dissipation: 2500 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 30 C
• Number Of Channels: 1 Channel
• Frequency (max): 849MHz
• Power Supply Requirement: Single
• Single Supply Voltage (min): 3.2V
• Single Supply Voltage (typ): 3.3V
• Single Supply Voltage (max): 4.2V
• Package Type: SMT
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Operating Temperature Classification: Commercial
• Operating Temp Range: -30C to 85C
• Pin Count: 10
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• P1db: -
• Test Frequency: -
• Lead Free Status / Rohs Status: Compliant

Design Tips to use Vcntl pin
Power Amplifier Control Using Vcntl Pin on ACPM-7813
Power amplifier control scheme in CDMA systems is
one of the important and challenging aspects of CDMA-
based handset design. Handset designers must balance
maintaining adequate linearity while optimizing
efficiency at high, medium and low output power
levels. The primary method to achieve these goals is
to adjust the bias of the PA as a function of output
power. Theoretically, the best efficiency would be
achieved when the bias of the PA is continually
adjusted based on the output power requirement of
the PA. However, implementing this type of circuit can
be complex and costly. Therefore several different
approaches have been developed to provide an
acceptable trade-off between optimum efficiency and
optimum manufacturability. This application section
reviews four methods of controlling the bias of a CDMA
power amplifier: fixed, step, logical and dynamic.
Power Mode
Shut Down
High Power
11
To Duplexer
Vdd1
Vcntl
Vdd2
PA
Vbias
PA_ON
LOW
HIGH
Switch Circuit for PA
PMIC or LDO
Vcntl
Battery
Enable
Vcntl
0V
2.5V
TxIC
Note: PMIC: Power Management IC
LDO: Low Drop Output (Regulator)
Power Range
—
- 28.5 dBm
1. Fixed Bias Control
Using a fixed bias point on the PA is the traditional
method, and it is the simplest. For example, a fixed
control voltage of 2.5V is recommended when using
Avago Technologies Power Amplifier, 2.5V Vcntl for
ACPM-7813. The Vcntl pin on the PA is controlled by
PA_ON pin of the baseband IC. When PA_ON is HIGH,
the output RF signal of the PA is enabled, enabling
the subscriber unit to transmit the required data. The
switch circuit also controls the on/off state of the PA.
Below is an example of how to control the operation
of the ACPM-7813 using the PA_ON and Vcntl pin of
the PA.
PA_ON
Baseband
IC