XBP09-DMDK Digi International, XBP09-DMDK Datasheet - Page 6

• Manufacturer Part Number: XBP09-DMDK
• Description: KIT STARTER PROMESH XBEE PRO
• Manufacturer: Digi International
• Series: XBEE-PRO™r
• Type: Transceiver, XBeePror

Specifications of XBP09-DMDK

• Frequency: 900MHz
• Wireless Frequency: 900 MHz
• Interface Type: RS-232, USB, UART
• Modulation: FHSS
• Security: 128 bit AES
• Operating Voltage: 3.3 V
• Output Power: 50 mW
• Antenna: RPSMA
• For Use With/related Products: Xbee-PRO Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1130

The characters in blue are
entered by the user and
transmitted. Those in red are
received characters.
10. Connect another XBee to your computer (USB or RS-232).
11. Open another X-CTU window and select the corresponding COM port for this new radio.
12. Set SP to 3E8 in hex and SM to 4-CYCLIC and click “Write”.
13. Repeat with a third module/interface board assembly.
14. Go to the Terminal tab in all three instances of X-CTU. After a couple of cycles, you will
15. Type in some characters while the radios are awake (CTS is on). The UART is active when
CONFIGURE REMOTE MODULES
Figure 5. Terminal Tab
These can also be configured "over-the-air" using X-CTU. This can be done through
the Modem Configuration tab using the Remote Configuration feature at the top of the
window. [Figure 6].
Click "Open Com Port" and "Discover" from the menu bar at the top of the window.
A list of nodes in the network will populate the screen. By selecting a particular node
from the list, you can interact with it as if it was connected to the PC directly.
see the CTS lines asserting and de asserting synchronously as all the radios cycle in and
out of sleep.
CTS is asserted. [Figure 5]