F2M01SXA-S01-B Free2Move, F2M01SXA-S01-B Datasheet - Page 5

• Manufacturer Part Number: F2M01SXA-S01-B
• Description: SERIAL PORT PLUG CBL
• Manufacturer: Free2Move

Specifications of F2M01SXA-S01-B

• Function: Transceiver, Bluetooth
• Modulation Or Protocol: Bluetooth v2.0 +EDR
• Frequency: 2402MHz ~ 2480MHz
• Applications: General Purpose
• Interface: RS-232
• Sensitivity: -90dBm
• Power - Output: 16dBm
• Data Rate - Maximum: 38.4kbps
• Features: 300m line of sight
• Voltage - Supply: 5 V ~ 30 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 647-1030

2.2
The blue LED indicates if there are data transmitted from and to the Plug via the connected D-sub. The
indication is on as default but is possible to disable during configuration.
2.3
The button has two functions depending on the current state of the device.
2.3.1
The Auto connect feature can be activated by pressing the button down for more than 15 seconds. The
F2M01SXA will now start to search and connect to the first available remote devices supporting SPP (Serial
Port Profile) in reachable distance. It can’t be easier to connect two F2M01SXA to each other; simply push
down the button on ONE of the device and they will try to pair. The F2M01SXA will change state to
“connected” if Auto connect was successful.
2.3.2
It is possible to disconnect an active Bluetooth connection (State: connected) by simply pressing the button.
2.4
The 9 pin D-sub is RS-232 compatible and support baud rates up to 230400bps. The F2M01SXA has
signaling as a DCE (Data Communication Equipment) and is intended to be connected to a DTE (Data
Terminal Equipment) e.g. a Computer.
The F2M01SXA has hardware flow control (CTS/RTS signals) activated by default and is recommended to
be used to get reliable data transmissions. It is though possible to deactivate Hardware flow control by
configuration.
The two extra RS-232 signals; DTR and DSR can be configured in three different modes.
2.4.1
1
2
3
4
5
6
7
8
9
Pin
1. Auto connect if the button is pressed for more than 15 seconds
2. Disconnect
1. Emulate serial handshaking lines
2. Bluetooth control – The DTR signal is used to disconnect an active Bluetooth connection and the
3. Don’t care. The state of the signals is not used.
DCD
TxD
RxD
DTR
GND
DSR
CTS
RTS
Vcc Power
DSR signal will indicate when you have an established Bluetooth connection.
Blue LED
Button
D-sub
Auto connect
Disconnect
Pinout
signal
Not connected
Output
Input
Input
Ground
Output
Input
Output
Input 5-30V
Direction
© 2008 Free2move AB
Serial Port Plug - F2M01SXA
Datasheet
Serial Port Plug connector (female)
5
9
4
8
3
7
2
6
1
Rev: 2008-12-09
Page 5(10)