X09-009PKC-UA Digi International/Maxstream, X09-009PKC-UA Datasheet - Page 6

• Manufacturer Part Number: X09-009PKC-UA
• Description: MODEM RF 900MHZ 9600BPS USB
• Manufacturer: Digi International/Maxstream
• Series: XStream™r

Specifications of X09-009PKC-UA

• Function: Transceiver, FHSS
• Modulation Or Protocol: FHSS, FSK
• Frequency: 900MHz
• Applications: ISM
• Interface: USB
• Sensitivity: -110dBm
• Power - Output: 20dBm (100mW)
• Data Rate - Maximum: 10 kbps
• Voltage - Supply: 5 V ~ 12 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -

Figure 1‐01. Front View
Figure 1‐02. Back View
For CAD drawings and exact measurements, refer to the Mechanical Drawings section [next page].
1‐02a. Reset Switch
XStream‐PKG‐U™ USB RF Modem – Product Manual v4.2B5 [2006.02.27]
* NOTE: Disconnect the USB cable before
connecting or removing power from the
Power Connector [1-01d]. This port does not
require power unless insufficient power is
available from the USB Port (< 500 mA).
1‐01a. I/O & Power LEDs
1‐02b. Config Switch
1.3. External Interface
1‐01b.
RSSI LEDs
1.3.1. Front and Back Views
1‐01c. USB Port
1‐02c. Antenna Port
© 2006 MaxStream, Inc. Confidential and Proprietary
1‐01d. Power
Connector*
1-01a. I/O & Power LEDs
1-02a. Reset Switch
1-01b. RSSI LEDs
1-01c. USB Port
1-01d. Power Connector *
1-02b. Config (Configuration) Switch
1-02c. Antenna Port
LEDs indicate modem activity as follows:
Reset Switch forces the RF Modem to reset (or re-boot).
RSSI LEDs indicate the amount of fade margin present in an active
wireless link. Fade margin is the difference between the incoming
signal strength and the modem’s receiver sensitivity.
Standard Type-B USB connector – This port can also be used to
power the XStream-PKG-U unit.
5-12V Power Connector.
The Config Switch provides an alternate way to enter AT Command
Mode. To enter Command Mode at the Modem’s default baud rate:
Simultaneously press the Reset [1-02a] and Config switches;
release the Reset Switch; then after 1 second, release the Config
Switch. The RF Modem then enters AT Command Mode at the
modem’s default baud rate.
Antenna Port is a 50 Ω RF signal connector for connecting to an
external antenna. Connector type is Reverse Polarity (RPSMA)
female. The RPSMA has threads on the outside of a barrel and a
male center conductor.
Yellow (top LED) =
Green (middle)
Red (bottom)
when powered and pulses off briefly during RF transmission)
3 LEDs ON
2 LEDs ON
1 LED ON
0 LED ON
=
=
=
=
=
Very Strong Signal (> 30 dB fade margin)
Strong Signal (> 20 dB fade margin)
Moderate Signal (> 10 dB fade margin)
Weak Signal (< 10 dB fade margin)
=
Serial Data Out (to host)
Serial Data In (from host)
Power/TX Indicator (Red light is on
6