MC33591FTAR2 Freescale Semiconductor, MC33591FTAR2 Datasheet - Page 4

• Manufacturer Part Number: MC33591FTAR2
• Description: IC RF RECEIVER 315,434MHZ 24LQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC33591FTAR2

• Frequency: 315MHz, 434MHz
• Sensitivity: -105dBm
• Data Rate - Maximum: 11 kBaud
• Modulation Or Protocol: FSK, OOK
• Applications: General Data Transfer
• Current - Receiving: 5.7mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 1.9 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 24-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -
• Memory Size: -
• Other names: MC33591FTAR2TR

RECEIVER FUNCTIONAL DESCRIPTION
RECEIVER FUNCTIONAL DESCRIPTION
diagram (see figure 1). It is fully compatible with the TANGO3 transmitter.
AGC controlled gain stage and OOK/FSK demodulators, the desired modulation type being selectable by the SPI
interface. The data output from the circuit may either be the data comparator output, or, if Data Manager is
enabled, the SPI port.
by the choice of the crystal frequency.
accomodate applications where no bus interface is available the circuit defaults at power-on to a standard
operating mode.
internally wait-and-sleep cycled to reduce the power consumption. At any time, a high level on STROBE
overrides the internal timer output and wakes up ROMEO2. When the circuit is switched into sleep mode its
current consumption is approximately 100µA. The circuit configuration which has previously been programmed is
retained.
THE LOCAL OSCILLATOR PLL
oscillator reference. The loop filter has been integrated in the IC. Practical limits upon the values of components
which may be integrated mean that the local oscillator performance may be slightly improved by using an
external PFD filter, shown in Figure 2. In this way the user may choose to have optimum performance with the
addition of external filter components. The PLL gain may be programmed by bit PG: it is recommended that this
bit be set to 1, corresponding to low loop gain.
4
The basic functionality of the ROMEO2 receiver may be seen by reference to the accompanying block
The RF section comprises a mixer with image cancelling, followed by an IF band-pass filter at 660kHz, an
The local oscillator is controlled with a PLL referenced to the crystal oscillator. The received channel is defined
An SPI bus permits programming the modulation type, data rate, UHF frequency, ID word etc., though to
Depending upon the configuration, the circuit can be either externally strobed by the STROBE input or
The PLL is tuned by comparing the local oscillator frequency, after suitable division, with that of the crystal
Freescale Semiconductor, Inc.
For More Information On This Product,
MC33591 Technical Data
Figure 2 : External loop filter
Go to: www.freescale.com
C1=4.7nF, C2=390pF, R=1kW
MOTOROLA