RN-131G Roving Networks Inc, RN-131G Datasheet - Page 10

• Manufacturer Part Number: RN-131G
• Description: MODULE WIFLY GSX 802.11 SMD
• Manufacturer: Roving Networks Inc

Specifications of RN-131G

• Frequency: 2.4GHz
• Data Rate - Maximum: 1Mbps
• Modulation Or Protocol: 802.11 b/g
• Applications: Home Automation, Security
• Power - Output: 18dBm
• Sensitivity: -85dBm
• Voltage - Supply: 3 V ~ 3.7 V
• Current - Receiving: 40mA
• Current - Transmitting: 210mA
• Data Interface: PCB, Surface Mount
• Memory Size: 8Mb Flash, 128kB RAM
• Antenna Connector: On-Board, Chip, U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Modulation: DSSS
• Security: WEP 128, WPA2-PSK
• Operating Voltage: 3.3 V
• Antenna: Chip, U.FL
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 740-1028

11. Sensor Interfaces. Inputs must not exceed 1.2V. Sensitivity saturates at 400 mV.
12. Adhoc mode and Restoring Factory Settings. Adhoc mode is controlled through GPIO-9. It is a good idea to
Compliance Information
Ordering Information
Roving Networks reserves the right to make corrections, modifications, and other changes to its products,
documentation and services at any time. Customers should obtain the latest relevant information before placing
orders and should verify that such information is current and complete.
Roving Networks assumes no liability for applications assistance or customer product design. Customers are
responsible for their products and applications using Roving Networks components. To minimize the risks associated
with customer products and applications, customers should provide adequate design and operating safeguards.
RN-131G-EVAL
Visit
RN-UFL-SMA6
The power consumption in sleep mode without these signals connected to a pull down is 655uA
connect pin 24, GPIO-9 to a switch or jumper connected to a pull up. When GPIO-9 is driven high at power up
the module will be in Adhoc mode. If GPIO-9 is then toggled low 5 times, the initial factory default configuration
will be RESTORED. This is useful for cases where the module is mis-configured and is no long responding.
FCC
IC
CE
REG
RADIO
EMC
SAFETY
RoHs
RN-SMA4-RP
Part Number
RN-131G
RN-131C
RN-134
www.rovingnetworks.com
http://www.rovingnetworks.com
809 University Avenue
Industrial Temperature (-30 to + 85 C ) With chip antenna and U.FL connector
Commercial Temperature (0 to + 70 C ) With chip antenna and U.FL connector
Development Kit for the RN-131G (Includes the RN-131G module)
SuRFboard carrier PCB for RN-131, RS-232, LEDs, power regulator. Sensor connections
4” external antenna with reverse polarity SMA connector. Used with RN-UFL-SMA6
6 inch cable with U.FL connector on one end and SMA on the other
For other configurations, contact Roving Networks directly.
Copyright © 2009 Roving Networks. All rights reserved.
•
Los Gatos, CA 95032
EN 301489-1 V1.8.1 (04/2008), EN 301489-17 V1.3.2 (04/2008)
for current pricing and a list of distributors carrying our products.
~ page 10 ~
ID U3O-G2M5477 Part 15.247
EN 60950-1:2001+A11:2004
EN 300328 V1.7.1 (10/2006)
•
Tel [phone]
(canada) RSS-210
U9M20901-1000-C
EU ID # 0681
Compliant
Description
RN-131G & RN-131C
• [e-mail]
RN-131-DS v2.5 12/2/2010