F2M03ALA-S01 Free2Move, F2M03ALA-S01 Datasheet - Page 36

• Manufacturer Part Number: F2M03ALA-S01
• Description: MOD BLUETOOTH V2.0+EDR SPP W/ANT
• Manufacturer: Free2Move

Specifications of F2M03ALA-S01

• Frequency: 2402MHz ~ 2480MHz
• Data Rate - Maximum: 3Mbps
• Modulation Or Protocol: BlueCore Serial (BCSP)
• Applications: Automotive Systems, Consumer Systems
• Power - Output: 4dBm
• Sensitivity: -86dBm
• Voltage - Supply: 2.2 V ~ 4.2 V
• Current - Transmitting: 75mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Current - Receiving: -
• Other names: 647-1026-2

Rev: a
Low power Audio Bluetooth™ Module with antenna F2M03ALA
Datasheet
6.5
Serial Peripheral Interface
F2M03ALA is a slave device that uses terminals SPI_MOSI, SPI_MISO, SPI_CLK and SPI_CSB. This
interface is used for program emulation/debug and IC test. It is also the means by which the F2M03ALA
flash may be programmed, before any 'boot' program is loaded.
The SPI signals should be routed out from the module if you need to upgrade the firmware on the module in
the future when the module is already soldered.
Note:
This interface is not a user interface and only used for initial download and configuration of the firmware for the module.
2
6.6 I
C Interface
2
PIO[8:6] can be used to form a master I
C interface. The interface is formed using software to drive these
lines. Therefore, it is suited only to relatively slow functions such as driving a dot matrix liquid crystal display
(LCD), keyboard scanner or EEPROM.
Notes:
2
The I
C interface is controlled by firmware specific settings. Please see specific firmware datasheet if the interface is available
PIO lines need to be pulled-up through 2.2k: resistors.
PIO[7:6] dual functions, UART bypass and EEPROM support, therefore, devices using an EEPROM cannot
support UART bypass mode.
For connection to EEPROMs, contact Free2move for information about devices that are currently supported.
Example EEPROM Connection
© 2007 Free2move AB
Page 36(51)