F2M03MLA-S03 Free2Move, F2M03MLA-S03 Datasheet - Page 42

• Manufacturer Part Number: F2M03MLA-S03
• Description: MOD BLUETOOTH V2.0 W/ANTENNA
• Manufacturer: Free2Move

Specifications of F2M03MLA-S03

• Frequency: 2.4GHz
• Data Rate - Maximum: 3Mbps
• Modulation Or Protocol: Bluetooth v2.0+EDR, Class 1, 2 & 3
• Applications: Bluetooth v2.0
• Power - Output: 7.9dBm ~ 8.6dBm
• Sensitivity: -85dBm
• Voltage - Supply: 3.1 V ~ 3.6 V
• Current - Receiving: 45mA
• Current - Transmitting: 75mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Other names: 647-1015-2; F2M03MLA-S03-R1B

9.3 FCC
FCC-B Radio Frequency Interference Statement
This deceive has been tested and found to comply with the limits for a Class-B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used according with the instruction manual,
may cause harmful interference to radio communication. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be required to correct the interference at his
own expense.
Notice1
The changes or modifications not expressly approved by the party responsible for the compliance could
void the user’s authority to operate the equipment.
Notice 2
Shielded interface cables an A.C. power cord, if any, must be used in order to comply with the emission
limits.
Notice 3
This modular transmitter uses an electronic display of the FCC identification number, the information must
be readily accessible on the device in which it is installed.
The FCC ID can be read from the UART of the device.
UART Settings:
Baud rate: 38400bps
Data bits: 8
Parity: None
Stop bits: 1
Send command: “VERSION” (ASCII characters) over the UART and the module will respond with software,
hardware information and the FCC ID.
If the module is installed inside another device, then the outside of the device into which
the module is installed must display a label referring to the enclosed module. This exterior
label can use wording such as the following: “Contains FCC certified transmitter module(s).”
Any similar wording that expresses the same meaning may be used.
FCC ID R47F2M03MLA
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference that
may cause undesired operation.
Low power Multimedia Bluetooth™ Module with antenna F2M03MLA
© 2007 Free2move AB
Datasheet
Page 42(42)
Rev: c