F2M03MLA-S01-R1A Free2Move, F2M03MLA-S01-R1A Datasheet - Page 35
![MOD BLUETOOTH MULTIMEDIA W/ANT](/photos/14/20/142010/mfg_f2m03mla-s01-r1a_sml.jpg)
F2M03MLA-S01-R1A
Manufacturer Part Number
F2M03MLA-S01-R1A
Description
MOD BLUETOOTH MULTIMEDIA W/ANT
Manufacturer
Free2Move
Datasheet
1.F2M03MLA-S03.pdf
(48 pages)
Specifications of F2M03MLA-S01-R1A
Frequency
2402MHz ~ 2480MHz
Data Rate - Maximum
1.5Mbps
Modulation Or Protocol
Bluetooth v2.0, Class 1, 2 & 3
Power - Output
8dBm
Sensitivity
-81dBm
Voltage - Supply
3.1 V ~ 3.6 V
Current - Transmitting
75mA
Data Interface
PCB, Surface Mount
Antenna Connector
On-Board, Chip
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Applications
-
Memory Size
-
Current - Receiving
-
Other names
647-1028-2
F2M03MLA-S04-R1A
F2M03MLA-S04-R1A
6.7 Power supply
The power supply for the F2M03MLA should be chosen carefully. Bad power supply can reduce the
performance and may damage the module. Please use the recommended voltage regulator or consult
Free2move if using another regulator. It is also essential to use a proper reset circuit to the module for
correct operation.
6.7.1
The F2M03MLA has one power supply, +VCC.
The voltage supplied should have low noise, less than 10mV rms between 0 and 10MHz. The transient
response of the regulator is also important. At the start of a Bluetooth packet, power consumption will jump
to high levels. The regulator should have a response time of 20µs or less; it is essential that the power rail
recovers quickly.
Recommended voltage regulator:
XC6209B332MR from Torex or TPS73633DBVTG4 from Texas Instrument
6.7.2
The F2M03MLA has an active low reset (pin nr: 38). The reset pin MUST be connected to either a reset-
circuit (voltage monitor) such as the TC1270ASVRCTR, MAX811S, DS1818 or using an I/O from a
microcontroller. Reset cannot be done with a R-C network. It is recommended to used one of the reset
circuits mentioned above. Special considerations must be taken when using an I/O from a microcontroller; a
pull-down resistor (typically 1.8kΩ) must be placed on the I/O-line.
It is recommended that RESET is applied for a period greater than 5ms.
At reset the digital I/O pins are set to inputs for bi-directional pins and outputs are tristated. The PIOs have
weak pull-downs.
Voltage regulator
Reset
Low power Multimedia Bluetooth™ Module with antenna F2M03MLA
© 2007 Free2move AB
Datasheet
Page 35(35)
Rev: c