XC09-038PKC-RA Digi International/Maxstream, XC09-038PKC-RA Datasheet - Page 19
![no-image](/images/no-image-200.jpg)
XC09-038PKC-RA
Manufacturer Part Number
XC09-038PKC-RA
Description
MODEM RF 900MHZ RS232/485 W/ACC
Manufacturer
Digi International/Maxstream
Series
9XCite™r
Datasheet
1.XC09-038PKC-RA.pdf
(39 pages)
Specifications of XC09-038PKC-RA
Frequency
900MHz
Data Rate - Maximum
38.4kbps
Modulation Or Protocol
FHSS, FSK
Power - Output
6dBm
Sensitivity
-104dBm
Voltage - Supply
2.85 V ~ 5.5 V
Current - Receiving
45mA
Current - Transmitting
55mA
Data Interface
Connector, Female DB-9
Antenna Connector
RP-SMA
Operating Temperature
0°C ~ 70°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Applications
-
Memory Size
-
9XCite‐PKG‐R™ RS‐232/485 RF Modem – Product Manual v2.1 [2007.01.04]
4.2. Configuration Software
Installation
Serial Communications Software
X-CTU is a MaxStream-provided software program used to interface with and configure Max-
Stream RF Modems. The software application is organized into the following four tabs:
Figure B‐1. X‐CTU User Interface (PC Settings, Range Test, Terminal and Modem Configuration tabs)
NOTE: PC Setting values are visible at the bottom of the Range Test, Terminal and Modem Configura-
tion tabs. A shortcut for editing PC Setting values is available by clicking on any of the values.
Double-click the "setup_X-CTU.exe" file and follow prompts of the installation screens. This file is
located in the 'software' folder of the MaxStream CD and also under the 'Downloads' section of the
following web page: www.maxstream.net/support/downloads.php
Setup
A terminal program is built into the X-CTU Software. Other terminal programs such as "HyperTer-
minal" can also be used to configure modems and monitor communications. When issuing AT
Commands through a terminal program interface, use the following syntax:
Figure B‐2. Syntax for sending AT Commands
NOTE: To read a parameter value stored in a register, leave the parameter field blank.
The example above issues the DT (Destination Address) command to change destination address
of the modem to "0x1F". To save the new value to the modem’s non-volatile memory, issue WR
(Write) command after modifying parameters.
To use the X-CTU software, a module assembly (An RF modem mounted to an interface Board)
must be connected to a serial port of a PC.
NOTE: Failure to enter AT Command Mode is most commonly due to baud rate mismatch. The
interface data rate and parity settings of the serial port ("PC Settings" tab) must match those of
the module (BD (Baud Rate) and NB (Parity) parameters respectively).
© 2007 MaxStream, Inc.
• PC Settings tab - Setup PC serial ports for interfacing with an RF modem
• Range Test tab - Test the RF modem's range and monitor packets sent and received
• Terminal tab - Set and read RF modem parameters using AT Commands
• Modem Configuration tab - Set and read RF modem parameters
19