XBP24-PKI-001-RA Digi International/Maxstream, XBP24-PKI-001-RA Datasheet - Page 6

• Manufacturer Part Number: XBP24-PKI-001-RA
• Description: MODULE 802.15.4 RS-232 ANT
• Manufacturer: Digi International/Maxstream
• Series: XBEE-PRO™r

Specifications of XBP24-PKI-001-RA

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: Home/Building Automation, Industrial Control, ZigBee™
• Power - Output: 0dBm
• Sensitivity: -92dBm
• Voltage - Supply: 2.8 V ~ 3.4 V
• Current - Receiving: 55mA
• Data Interface: Connector, Female DB-9
• Antenna Connector: RP-SMA
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Memory Size: -
• Current - Transmitting: -
• Other names: Q3255595

© 2008 Digi International, Inc.
XBee‐PRO PKG‐R® RS‐232 RF Modem – 802.15.4 ‐ Product Manual v1.xAx
Figure 1‐01. Front View
Figure 1‐02. Back View
1-02a. DIP Switch
1-01a. Reset Switch
1.3. External Interface
1-01e. Power Connector
1-01b. I/O & Power LEDs
1-01c. Serial Port
1-01d. RSSI LEDs
1-02b. Antenna Port
1-01a. Reset Switch
1-01b. I/O & Power LEDs
1-01c. Serial Port
1-01d. RSSI LEDs
1-01e. Power Connector
1-02a. DIP Switch
1-02b. Antenna Port
The Reset Switch is used to reset (re-boot) the XBee-PRO RS-232 RF
Modem. This switch only applies when using the configuration tabs of
Digi’s X-CTU Software.
LEDs indicate RF modem activity as follows:
Standard female DB-9 (RS-232) connector.
RSSI LEDs indicate the amount of fade margin present in an active
wireless link. Fade margin is defined as the difference between the
incoming signal strength and the modem's receiver sensitivity.
5-14 VDC power connector
DIP Switch functions are not supported in this release. Future down-
loadable firmware versions will support DIP Switch configurations.
Port is a 50Ω RF signal connector for connecting to an external
antenna. The connector type is RPSMA (Reverse Polarity SMA)
female. The connector has threads on the outside of a barrel and a
male center conductor.
Yellow (top LED) = Serial Data Out (to host)
Green (middle) = Serial Data In (from host)
Red (bottom)
(DIO5 Configuration) parameter)
3 LEDs ON
2 LEDs ON
1 LED ON
0 LED ON
= Very Strong Signal (> 30 dB fade margin)
= Strong Signal (> 20 dB fade margin)
= Moderate Signal (> 10 dB fade margin)
= Weak Signal (< 10 dB fade margin)
= Power/Association Indicator (Refer to the D5
6