ZB2430-Q-C-X-A Laird Technologies, ZB2430-Q-C-X-A Datasheet - Page 54

• Manufacturer Part Number: ZB2430-Q-C-X-A
• Description: MOD ANT CHIP ZIGBEE 2-100MW SMT
• Manufacturer: Laird Technologies
• Series: AeroCommr

Specifications of ZB2430-Q-C-X-A

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: AMR, ISM, Security and Access
• Power - Output: 10dBm ~ 20dBm
• Sensitivity: -99dBm
• Voltage - Supply: 3 V ~ 3.5 V
• Current - Receiving: 27mA
• Current - Transmitting: 25mA
• Data Interface: PCB, Through Hole
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

ZB2430 User’s Manual - v1.6
P e r f o r m S c a n
ZigBee Coordinators and Routers can manually scan selected channels for RF activity and other ZigBee devices/PAN
ID’s, etc.
Note: This command not valid for End Devices.
Command Definitions
32-bit channel mask
describing channels to scan
Scan Channel (Bytes 3-6)
Start Delimiter
• Scan Channel: A 32-bit channel mask specifying the channel(s) to include in the scan.
• Scan Type: Specifies the type of scan to perform. Energy scan, the device will tune to each channel &
• Scan Duration: Duration of the Active & Energy scans on each channel selected. Time is measured as:
• Max Results: The maximum number of results to report for Active scans. Ignored with Energy scan command.
• Status: Indicates the status of the current scan.
• Channel Number: 8-bit channel current measurement was taken from.
• Energy: The strength of the RF channel during the Energy scan.
• NWK Address: 16-bit NWK address of the neighboring device.
• PAN ID: The 16-bit PAN ID of the network to which the device belongs.
• Link Quality: The strength of the link between the current device and the device found during the Active scan.
0xCC
perform an energy measurement. Active scan, the device tunes to each channel, sends a beacon request
and listen for beacons from other ZigBee devices.
(15.36ms) x 2^(Scan Duration + 1)
Command Identifier
0x00: Energy detect scan
0x01: Active scan
0x8B
F i g u r e 2 1 : P e r f o r m S c a n C o m m a n d
Scan Type (Byte 7)
www.aerocomm.com
Request
Data
Scan Duration (Byte 8)
Range: 0x00-0x0E
A D V A N C E D N E T W O R K C O M M A N D S
Reserved (Byte 9)
Reserved.
Set to 0x00.
Max Results (Byte 10)
Maximum number
of results to return
4 9