UGWC621RSMA133 Unigen Corp, UGWC621RSMA133 Datasheet - Page 21

• Manufacturer Part Number: UGWC621RSMA133
• Description: MODULE NEMO BLUETOOTH RADIO
• Manufacturer: Unigen Corp

Specifications of UGWC621RSMA133

• Frequency: 2.4GHz ~ 2.48GHz
• Data Rate - Maximum: 3Mbps
• Modulation Or Protocol: BlueCore Serial (BCSP)
• Applications: General Purpose
• Power - Output: 7dbm
• Sensitivity: -89dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 40mA
• Current - Transmitting: 45mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

Solutions for a Real Time World
Key Features of the HCI Stack: Extra Functionality
The firmware extends the standard Bluetooth functionality with the following features:
For more details on the CSR Bluetooth stack, limitations and firmware refer to CSR’s firmware
release note “BlueCore Unified 23c Release Note (CS-116212-RNP3).pdf”
Re-Tek - 1573
[e-mail]
http://www.unigen.com
Copyright Unigen Corporation, 2008
• Supports BlueCore Serial Protocol (BCSP), a proprietary, reliable alternative to the standard
• Provides a set of approximately 50 manufacturer-specific HCI extension commands. This
• A block of BCCMD commands provides access to the chip's Persistent Store (PS)
• A UART break condition can be used in three ways:
• A block of Bluetooth radio test or BIST commands allows direct control of the chip's radio.
• Hardware low power modes: Shallow Sleep and Deep-Sleep. The chip drops into modes
• SCO channels are normally routed via HCI (over BCSP). However, up to three SCO
Bluetooth UART Host Transport
command set, called BlueCore Command (BCCMD), provides:
configuration database. The database sets the device's Bluetooth address, Class of Device,
Bluetooth radio (transmit class) configuration, SCO routing, LM, constants, etc.
This aids the development of modules' radio designs, and can be used to support Bluetooth
qualification.
that significantly reduce power consumption when the software goes idle.
channels can be routed over the chip's PCM ports (at the same time as routing any
remaining SCO channels over HCI).
o Access to the chip's general-purpose PIO port
o The negotiated effective encryption key length on established Bluetooth links
o Access to the firmware's random number generator
o Controls to set the default and maximum transmit powers; these can help minimize
o Dynamic UART configuration
o Bluetooth radio transmitter enable/disable. A simple command connects to a
o Presenting a UART break condition to the chip can force the chip to perform a
o Presenting a break condition at boot time can hold the chip in a low power state,
o With BCSP, the firmware can be configured to send a break to the host before
interference between overlapping, fixed-location piconets
dedicated hardware switch that determines whether the radio can transmit.
hardware reboot
preventing normal initialization while the condition exists
sending data. (This is normally used to wake the host from a Deep-Sleep state.)
NEMO Bluetooth Radio Module
- 21 -
45388 Warm Springs Blvd. Fremont, CA 94539
TEL: [phone] FAX: [phone]
Customer Comment Line: [phone]
Datasheet