UGWC621RSMA133 Unigen Corp, UGWC621RSMA133 Datasheet - Page 36

• Manufacturer Part Number: UGWC621RSMA133
• Description: MODULE NEMO BLUETOOTH RADIO
• Manufacturer: Unigen Corp

Specifications of UGWC621RSMA133

• Frequency: 2.4GHz ~ 2.48GHz
• Data Rate - Maximum: 3Mbps
• Modulation Or Protocol: BlueCore Serial (BCSP)
• Applications: General Purpose
• Power - Output: 7dbm
• Sensitivity: -89dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 40mA
• Current - Transmitting: 45mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

Solutions for a Real Time World
Re-Tek - 1573
94539
[e-mail]
http://www.unigen.com
Copyright Unigen Corporation, 2008
Name
SLAVE_MODE_EN
SHORT_SYNC_EN
SIGN_EXTENDED_EN
LSB_FIRST_EN
TX_TRISTATE_EN
TX_TRISTATE_RISING_EDGE_EN
Name
CNT_LIMIT
CNT_RATE
SYNC_LIMIT
Bit Position
[12:0]
[23:16]
[31:24]
Table 7: PSKEY_PCM_LOW_JITTER_CONFIG Description
Table 8: PSKEY_PCM_CONFIG32 Description
NEMO Bluetooth Radio Module
Position
Bit
0
1
2
3
4
5
6
7
Description
Sets the PCM CLK counter limit
Sets the PCM CLK count rate
Sets the PCM SYNC division relative to PCM CLK
- 36 -
Description
Set to 0
0 = Master mode with internal generation of the
BT_PCM_CLK_P and BT_PCM_SYNC_P.
1 = Slave mode requiring externally generated PCM
CLK and the PCM SYNC signals.
0 = Long Frame Sync mode (rising edge indicates
start of frame).
1 = Short Frame Sync mode (falling edge indicates
start of frame).
Set to 0
0 = Padding of 8 or 13-bit voice sample into a 16-bit
slot by inserting extra LSBs. When padding is
selected with 13-bit voice sample, the 3 padding bits
are the audio gain setting; with 8-bit sample the 8
padding bits are zeroes.
1 = Sign-extension.
0 = MSB first of transmit and receive voice samples.
1 = LSB first of transmit and receive voice samples.
0 = Drive PCM_OUT continuously.
1 = Tri-state BT_PCM_TXD_P immediately after
falling edge of BT_PCM_CLK_P in the last bit of an
active slot, assuming the next slot is not active.
0 = Tri-state BT_PCM_TXD_P immediately after
falling edge of BT_PCM_CLK_P in last bit of an active
slot, assuming the next slot is also not active.
1 = Tri-state BT_PCM_TXD after rising edge of
BT_PCM_CLK_P.
TEL: [phone] FAX: [phone]
Customer Comment Line: [phone]
45388 Warm Springs Blvd. Fremont, CA
Datasheet