HEDS-8903 Avago Technologies US Inc., HEDS-8903 Datasheet - Page 9

• Manufacturer Part Number: HEDS-8903
• Description: WIRE HARNESS FOR 3CH HEDX-5XXX
• Manufacturer: Avago Technologies US Inc.

Specifications of HEDS-8903

• Accessory Type: Wire Harness
• Number Of Channels: 3
• Product: Optical
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: HEDx-5xxx Series
• For Use With: 516-2025 - ENCODER OPT 3CH QUICK ASSM516-2023 - ENCODER OPT 2CH QUICK ASSM516-2022 - ENCODER OPT 3CH QUICK ASSMHEDS-5540C12 - ENCODER OPTICAL 100 CPR 6MM SHFT
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 516-2027

Encoder Mounting and Assembly
1a. For HEDS-5500 and 5600: Mount encoder base plate
1b. For HEDS-5540, 5640 and HEDM-5500, 5600, 5540 :
1c. It is recommended that adhesive* is applied to the
2.
3a. Push the hex wrench into the body of the encoder to
3b. While continuing to apply a downward force, rotate
3c. Remove the hex wrench by pulling it straight out of
4.
The encoder is ready for use!
9
Slip alignment tool onto motor shaft. With alignment
tool in place, mount encoder baseplate onto motor
as shown above. Tighten screws. Remove alignment
tool.
screw-baseplate interface to prevent screw loosening
due to effect of high temperature on plastic
onto motor. Tighten screws. Go on to step 2.
Snap encoder body onto base plate locking all 4
snaps.
ensure that it is properly seated into the code wheel
hub set screws. Then apply a downward force on the
end of the hex wrench. This sets the code wheel gap
by levering the code wheel hub to its upper position.
the hex wrench in the clockwise direction until the
hub set screw is tight against the motor shaft (The
recommended torque to tighten the setscrew is 15-
18 ozf.inch). The hub set screw attaches the code
wheel to the motor’s shaft.
the encoder body.
Use the center screwdriver slot, or either of the two
side slots, to rotate the encoder cap dot clockwise
from the one dot position to the two dot position. Do
not rotate the encoder cap counterclockwise beyond
the one dot position.