ATMEGA165PV-8MNR Atmel, ATMEGA165PV-8MNR Datasheet - Page 163

• Manufacturer Part Number: ATMEGA165PV-8MNR
• Description: IC MCU AVR 16K 8MHZ 64MLF
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA165PV-8MNR

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI, UART/USART, USI
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 54
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-VFQFN, Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

18.3.4
18.4
8019K–AVR–11/10
Frame Formats
Synchronous Clock Operation
When synchronous mode is used (UMSELn = 1), the XCK pin will be used as either clock input
(Slave) or clock output (Master). The dependency between the clock edges and data sampling
or data change is the same. The basic principle is that data input (on RxD) is sampled at the
opposite XCK clock edge of the edge the data output (TxD) is changed.
Figure 18-3. Synchronous Mode XCK Timing.
The UCPOLn bit in UCSRnC selects which XCK clock edge is used for data sampling and which
is used for data change. As
at rising XCK edge and sampled at falling XCK edge. If UCPOLn is set, the data will be changed
at falling XCK edge and sampled at rising XCK edge.
A serial frame is defined to be one character of data bits with synchronization bits (start and stop
bits), and optionally a parity bit for error checking. The USART accepts all 30 combinations of
the following as valid frame formats:
• 1 start bit
• 5, 6, 7, 8, or 9 data bits
• no, even or odd parity bit
• 1 or 2 stop bits
A frame starts with the start bit followed by the least significant data bit. Then the next data bits,
up to a total of nine, are succeeding, ending with the most significant bit. If enabled, the parity bit
is inserted after the data bits, before the stop bits. When a complete frame is transmitted, it can
be directly followed by a new frame, or the communication line can be set to an idle (high) state.
Figure 18-4 on page 164
brackets are optional.
UCPOL = 1
UCPOL = 0
RxD/TxD
RxD/TxD
XCK
XCK
illustrates the possible combinations of the frame formats. Bits inside
Figure 18-3
shows, when UCPOLn is zero the data will be changed
Sample
Sample
ATmega165P
163