PIC-WEB Olimex Ltd., PIC-WEB Datasheet - Page 3

• Manufacturer Part Number: PIC-WEB
• Description: MCU, MPU & DSP Development Tools TCP-IP DEV BRD FOR PIC18F67J60
• Manufacturer: Olimex Ltd.

Specifications of PIC-WEB

• Processor To Be Evaluated: PIC18F67J60
• Data Bus Width: 8 bit, 16 bit
• Interface Type: RS-232, Ethernet, I2C, SPI
• Dimensions: 60 mm x 65 mm
• Operating Supply Voltage: 5 V
• Tool Type: Development Kit
• Core Architecture: PIC
• Cpu Core: PIC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1701532 25R4931

ELECTROSTATIC WARNING
BOARD USE REQUIREMENTS
The PIC-WEB board is shipped in protective anti-static packaging. The board must
not be subject to high electrostatic potentials. General practice for working with
static sensitive devices should be applied when working with this board.
Cables:
meter USB A-B cable to connect
or Serial DB9 cable in case of
tools. You will need a serial cable if not for programming, than for configuring the
board. You will also need a Crossover Ethernet cable.
Hardware:
applicable, for example PIC-ICD2, PIC-ICD2-POCKET, PIC-ICD2-TINY or other
compatible programming/debugging tool.
!!!Warning!!!
ICD2-POCKET or PIC-ICD2-TINY, before connecting the programmer to your
target board, you should first connect the programmer to your computer and open
MPLAB. There, first from menu Configure – Select Device – choose the
microcontroller you are about to program, then from menu Programmer – Select
Programmer – choose MPLAB ICD 2, wait while MPLAB is downloading operation
system, and after ICD2 is connected – check in menu Programmer – Settings –
Power – there is option – Power target circuit from MPLAB ICD 2 – this option
should be forbidden, you could not select it. Now it is safe to connect the
programmer to your target board.
Software:
Standart EVAL Version (www.microchip.com). TCP/IP stack
(www.microchip.com). It is possible that the stack might not function properly if
used with later versions of MPLAB IDE. You will also need a terminal program
configured at 19 200 bps, 8N1 and no flow control.
When you want to program this microcontroller with PIC-ICD2, PIC-
Depends on the used programming/debugging tool. It could be 1.8
Programmer/Debugger – most of Olimex programmers are
PIC-WEB is tested with MPLAB IDE v.8.14 + C18 compiler Free
PIC-ICD2-TINY
Page3
PIC-ICD2
or
PIC-ICD2-POCKET
or other programming/debugging
to USB host on PC