CS-E9302 Olimex Ltd., CS-E9302 Datasheet - Page 2

• Manufacturer Part Number: CS-E9302
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR EP9301/ EP9302 ARM920T
• Manufacturer: Olimex Ltd.

Specifications of CS-E9302

• Processor To Be Evaluated: EP9302 ARM920T
• Interface Type: RS-232, Ethernet, USB, I2S, JTAG, SPI, UART
• Dimensions: 110 mm x 90 mm
• Operating Supply Voltage: 5 V
• Silicon Manufacturer: Cirrus
• Core Architecture: ARM
• Core Sub-architecture: ARM9
• Silicon Core Number: EP9
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1776317 52R3485

INTRODUCTION:
BOARD FEATURES:
ELECTROSTATIC WARNING:
BOARD USE REQUIREMENTS:
CS-E9302 is powerful development board for 200MHz Cirrus Logic EP9302
ARM920T microprocessors with two USB hosts, two RS232 ports, 100Mbit
Ethernet, SD-MMC
transciever, JTAG, UEXT, EXT, ADC connectors for additional peripherials.
The CS-E9302 development board is shipped in protective anti-static
packaging. The board must not be subject to high electrostatic potentials.
General practice for working with static sensitive devices should be applied
when working with this board.
Hardware:
Software:
Cables:
-
-
-
-
-
-
-
-
-
-
-
-
-
-
MCU: EP9302 ARM920T 200Mhz, 16+16KB instruction and data
cache, MMU, SDRAM, SRAM, FLASH external bus controller 100Mhz
bus, 100Mbit Ethernet MAC, two UARTS, two USB 2.0 ports, IrDA,
ADC, SPI, I2S Audio, AC97, DMA 12 ch, RTC, dual PLL, WDT, 2- 16
bit, 1- 32 bit TIMERS, boot ROM, interrupt controller;
External SDRAM 32MB (16MB x16bit) 7.5 ns /133MHz;
External Flash 16MB (8MB x16 bit) 80 ns;
ETHERNET 10/100 PHY KS8721BL;
2 x RS232 drivers and connectors;
2 x USB host connectors;
SD/MMC card;
IrDA transciever on board;
UEXT connector with I2C, SPI, RS232 and power supply for
connecting add-on modules like RF link, MP3, etc available from
Olimex;
JTAG interface;
ADC extension port;
Power supply plug in jack;
Linux 2.4
ready to load with Redboot are available on the supplement CD;
Dimensions: 110x90 mm (4.3 x 3.5").
Two DB9 female-female null modem type for connection with
serial COM port of PC host.
Crossed LAN cable for connection with PC or straight LAN
cable for connection with switch or router.
+5V/1A regulated power source.
The boards are delivered pre-loaded with Linux 2.6.
ARM-JTAG,
compatible tool only if you want to develop with JTAG,
usually with the pre-loaded linux RTOS this is not
necessary.
,
Linux 2.6
card, 16MB
and
ARM-USB-OCD,
NetBSD
NOR Flash,
sources and pre-build images
ARM-USB-TINY
32MB SDRAM,
or
other
IrDA