II-EVB-600-3-220 Connect One, II-EVB-600-3-220 Datasheet - Page 33

• Manufacturer Part Number: II-EVB-600-3-220
• Description: MCU, MPU & DSP Development Tools iChip CO2464SEC EVAL BOARD 220V
• Manufacturer: Connect One

Specifications of II-EVB-600-3-220

• Processor To Be Evaluated: CO2064SEC
• Interface Type: RS-232, Ethernet
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

II-EVB-600 User Manual
3
This section describes the II-EVB-600 local firmware and parameters update capabilities using
the iChipConfig utility.
It also describes how to create and use parameter files (*.RPF).
3.1
The II-EVB-600 can be updated locally in one of two ways. You can upload the firmware directly
from the host (PC, in our case) via the RS232 interface, or from the external flash memory
provided on the II-EVB-600 via the SPI interface.
3.1.1
To load the iChip firmware from host memory via the RS232 serial interface, you need to obtain
the RAM version of the firmware flavor you wish to install from Connect One. The RAM version is
provided as two separate files: a version.hdr file and a version.dat file. The following procedure
assumes that you have a host application running on your PC, in which you insert appropriate
lines of code, as detailed below.
3.1.2
Miscellaneous Operational Features
1. Power up the II-EVB-600 and assert the MSEL pin for at least 5 seconds.
2. Use the connected UART at a baud rate between 9600 and 115200 to send a capital U
3. Send a capital L and wait for a > prompt.
4. Send the version.hdr file and wait for a > prompt.
5. Send the version.dat file.
6. The firmware is now loaded into iChip’s RAM and ready for use.
1. Invoke the iChipConfig utility.
character to the iChip. Wait for a > prompt.
Firmware and Parameters Update
Local Firmware Update
Loading the Firmware from Host
Loading the Firmware from SPI Flash Memory
Firmware and Parameters Update
28