PVZ2A103C04R00 Murata, PVZ2A103C04R00 Datasheet - Page 82

• Manufacturer Part Number: PVZ2A103C04R00
• Description: Trimmer Resistors - SMD 10Kohms Open 2mm Carbon
• Manufacturer: Murata
• Type: Trimming Potentiometerr

Specifications of PVZ2A103C04R00

• Resistance: 10 KOhms
• Power Rating: 0.1 Watt (1/10 Watt)
• Operating Temperature Range: - 25 C to + 85 C
• Element Type: Carbon
• Dimensions: 2.1 mm W x 2.7 mm L x 0.8 mm H
• Product: Single-Turn Trimmer Potentiometers
• Termination Style: Solder Pad
• Tolerance: 30 %
• Number Of Turns: 1
• Taper: Linear
• Temperature Coefficient: +/- 500 PPM / C
• Product Type: Single Turn
• Adjustment: Top Crossed
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
!Note
No.
13
14
Specifications and Test Methods
Continued from the preceding page.
Low Temperature Operation
(Only for PVF2 and
PVM4A---D01)
Rotational Life
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specifications before ordering.
Item
SMD Sealed Type/Lead Sealed Type Specifications and Test Methods
The trimmer potentiometer should be placed in a chamber at a temperature of -25±3°C (-55±3°C for PVM4A---
D01 series) 48±4 hours without loading. The trimmer potentiometer should be removed from the chamber, and main-
tained at a temperature of 25±5°C for 1-2 hours
1)PV-- series
Full rated continuous working voltage not exceeding the maximum rated voltage should be applied with the circuit
shown in the figure. The adjustment rotor (screw) should be continuously cycled through not less than 90% of effec-
tive-electrical rotational angle (number of turns), at the rate of 1 cycle for 5 seconds minimum to 2.5 minutes maxi-
mum for total of 200 cycles.
2) PVG3, PVG5 series
The adjustment rotor (screw) should be continuously cycled though not less than 90% of effective-electrical rotation-
al angle (number of turns), at the rate of 1 cycle for 5 seconds minimum to 2.5 minutes maximum for a total of 50
(100 for PVG5) cycles, without loading.
3) PVF2, PVM4A---D01 series
The wiper should be rotated over 90% of the effective rotational angle without loading at a speed of 10 cycles per
minute, for 100 cycles continuously.
End Terminal
Resistor 1
End Terminal
Figure 4
DC supply
End Terminal
Resistor 2 End Terminal
Test Methods
R50E13.pdf 04.6.11
81
9