EL4511CUZ-T7A Intersil, EL4511CUZ-T7A Datasheet - Page 24

• Manufacturer Part Number: EL4511CUZ-T7A
• Description: IC VID SYNC SEPARATR HDTV 24QSOP
• Manufacturer: Intersil
• Type: Synchronous Separatorr

Specifications of EL4511CUZ-T7A

• Applications: HDTV, Projectors, Set-Top Boxes
• Mounting Type: Surface Mount
• Package / Case: 24-SSOP (0.150", 3.90mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Application 3 (application using a microcontroller
interface)
In this example, the requirement is to provide the
synchronizing information in a video digitizing interface. This
example is very similar to the example in application 2. In
this example the incoming sync signals may come from one
of three sources. Computer, HDTV source or an NTSC/PAL
device.
As there is a Microcontroller connected in this example, a
32.768kHz XTAL is connected to pins 1 & 24; this will allow
the system microcontroller to gather timing information for
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
H SYNC
V SYNC
SYNCS
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
HDTV
CVBS
For information regarding Intersil Corporation and its products, see www.intersil.com
75Ω
24
75Ω
75Ω
FIGURE 12. APPLICATIONS DRAWING 3
4.7µF
620Ω
32.768kHz
CRYSTAL
75Ω
510pF
VIDEO SIGNALS (RGB)
VIDEO SIGNALS (HDTV)
VIDEO SIGNAL (CVBS)
0.1µF
+
100nF
EL4511
COMPONENT
COMPOSITE
10
24
11
9
4
1
HIN
VERTIN
SYNCIN
PDWN
XTAL
XTALN
the vertical rate. To enable the crystal oscillator, register 9,
bit 6 must be set to a high.
Note that a Low Pass Filter is in the NTSC/PAL signal path to
reduce noise, glitches and subcarrier. (In signals with bad
Croma/Luma gain balance, the subcarrier can extend into
the sync slicing level).
As some of the signals in this application were non standard
formats, the fixed slice mode is used by setting register 2,
bit 5 to a high. Register 1, bit 6 is also set to a high. This
forced the EL4511 to provide outputs even when the input
signals are not recognized by the internal algorithms.
EL4511
V
CC
BACKPORCH
VERTOUT
VBLANK
GNDA2
HOUT
16
22
21
20
2
VERTICAL
TIMING
HORIZONTAL
TIMING
VIDEO
CLAMP
PLL
COAST
TO MICROCONTROLLER
0.1µF
V
CC
November 12, 2010
FN7009.8