ADT7410TRZ Analog Devices Inc, ADT7410TRZ Datasheet - Page 10

• Manufacturer Part Number: ADT7410TRZ
• Description: IC SENSOR TEMP 16BIT I2C 8SOIC
• Manufacturer: Analog Devices Inc

Specifications of ADT7410TRZ

• Function: Temp Monitoring System (Sensor)
• Topology: ADC (Sigma Delta), Oscillator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -55°C ~ 150°C
• Output Type: I²C™
• Output Alarm: No
• Output Fan: No
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -55°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Ic Output Type: Digital
• Sensing Accuracy Range: ± 0.5°C
• Supply Current: 230µA
• Supply Voltage Range: 2.7V To 5.5V
• Resolution (bits): 16bit
• Sensor Case Style: SOIC
• No. Of Pins: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: EVAL-ADT7X10EBZ - BOARD EVAL FOR ADT7410
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

ADT7310
ONE-SHOT MODE
Setting Bit 5 to 1 and Bit 6 to 0 of the configuration register
(Register Address 0x01) enables the one-shot mode. When
this mode is enabled, the ADT7310 immediately completes a
conversion and then goes into shutdown mode.
Wait for a minimum of 240 ms after writing to the one-shot
bits before reading back the temperature from the temperature
value register. This time ensures that the ADT7310 has time to
power up and complete a conversion.
The one-shot mode is useful when one of the circuit design
priorities is to reduce power consumption.
DOUT
SCLK
DIN
CS
Figure 14. Typical SPI One-Shot Write to Configuration Register Followed by a Read from the Temperature Value Register
0x08
0x20
Rev. 0 | Page 10 of 24
FOR CONVERSION TO FINISH
WAIT 240ms MINIMUM
1 SPS MODE
In this mode, the part performs one measurement per second.
A conversion takes only 60 ms, and it remains in the idle state
for the remaining 940 ms period. This mode is enabled by
writing 0 to Bit 5 and 1 to Bit 6 of the configuration register
(Register Address 0x01).
DATA