AS5013-DB-2.1 austriamicrosystems, AS5013-DB-2.1 Datasheet - Page 4

• Manufacturer Part Number: AS5013-DB-2.1
• Description: BOARD DEMO EASYPOINT
• Manufacturer: austriamicrosystems
• Series: EasyPoint™r

Specifications of AS5013-DB-2.1

• Main Purpose: Interface, Hall Effect Sensor Human Interface Device (HID)
• Embedded: No
• Utilized Ic / Part: N40P112
• Primary Attributes: Analog Joystick with 3 Buttons
• Secondary Attributes: USB Interface
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AS5013-DB-2.1
Demoboard and Software Operation Manual
HID Joystick button I is controlled by the EP button (from the EasyPoint™ module) and Button
Mode 1: Push and hold Button
The LED “Center” blinks 4 times.
H
Mode 2: Push and hold Button
The LED “Hall Push” blinks 4 times.
H
The “Hall Push” is an algorithm running in the demoboard MCU, reading the five Hall Element C1..C5, and determine
if the EP button has been pushed, without any electrical contact. The restriction of this mode is that the detection is
w
Mode 3: Push and hold Button
The LED “Center” and “Hall Push” blink 4 times simultaneously.
This mode is similar to Mode 0, but the I²C communication between th
c
This mode is used for debug mode,
o
Firmwa
cable.
All the LEDs are ON. The AS5013 is in “Bootloader mode”. This mode is u
demoboard if a new file is available on the austriamicrosystems website:
http://www.austriamicrosystems.com/eng/Sup
Encoder/EasyPoint-AS5013-DB-Demoboard
In order to update the board:
www.austriamicrosystems.com
oordinate exchange only. The Hall Push function is totally disabled.
f signal and timing interpretation.
ID Joystick button I is controlled by the Button
ID Joystick button I is controlled by the Button
orking when the EasyPoint™ module button is pushed on the center position area.
1.
2.
3.
AMSFirmwareUpdater AS5013DB23.BIN silabs
4.
5.
re update mode:
Copy the directory 02_DemoBoard_FW\Fir
Copy the new binary file into this directory.
Edit the batch file UpdateFW 2.1.bat and change
Execute the batch file UpdateFW 2.1.bat.
At the end of the procedure, the demoboard restarts by itself.
Push and hold Button
and power up the demoboard with the USB cable.
and power up the demoboard with the USB cable.
and power up the demoboard with the USB cable.
if timing analysis, with e.g. an oscilloscope, is required, and simplifies the readout
port/Design-Resources/Demo-Eval.-Progr.-Boards/EasyPoint-Linear-
, and by the “Hall Push” function. EP button is disabled.
Revision 1.01
only. EP button is disabled
mware updater on the PC harddisk, e.g. c:\
simultaneously and power up the demoboard with the USB
the binary file name with the new one, e.g.
e MCU and AS5013 is restricted to XY
sed to update the firmware of the
.
4 – 16
s