CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 17

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

2.2.4 J7 Connector (Flexfilm)
Table 5: Signals on J7
J7
Pin Nr
1
2
3
4
5
6
Pin Name
DSR
VSS
VCC_3V3
DTR
RED/Mode
RESET
Signal Name
Hardware reset
Data Set Ready
Ground
Power
Data Terminal Ready
Red LED output
Version 1.16 - 2009-12
Signal
Level
CMOS
CMOS
Ground
3.3V
CMOS
CMOS
In
Out
Out
Type
In
Description
Active low. Must be open drain
collector.
See section 2.4 for design exam-
ples.
Active low.
Also used to control the power
saving mode “stop mode”.
See section 2.5 for more infor-
mation.
GND
3.0 – 6.0 VDC for
CB-OEMSPA311 modules
3.3 – 6.0 VDC for
CB-OEMSPA331 modules
Active low.
RED:
Logic Red LED Signal
(see Chapter 3, Table 14). Active
low.
Mode:
Not used on cB-0901.
This pin is also used to select
Logic level mode (instead of
RS232) for connectBlue product
with internal RS232 driver. To be
compatible with these products
check the datasheet for these
products about this signal.
The pin is not allowed to be pull-
down when using the SerialSe-
lect signals.
17