5300 3M, 5300 Datasheet - Page 4

• Manufacturer Part Number: 5300
• Description: Motor Splice Kit
• Manufacturer: 3M
• Series: 5300r

Specifications of 5300

• Kit Contents: 3 Splices, 3 Lug Covers, 3 Tubes Silicone Grease, 3 Mastic Sealing Strips
• Wire Size (awg): 16-12
• Insulator Material: EPDM Rubber
• Accessory Type: Motor Splice Kit
• Insulator Color: Black
• Rohs Compliant: Yes
• For Use With: Motor Leads Terminated With Compression Lugs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Appendix A
Splice Removal
1. Remove Vinyl Tape from end of Lug Cover. (Avoid use
2. Slide Lug Cover off of lugged or split-bolt connection.
3. If splice was sealed for moisture resistance: Remove
4. Remove nut and bolt (or split-bolt) to separate the
3M, Scotch and Scotchlok are trademarks of 3M.
IMPORTANT NOTICE
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability
associated with such use.
Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture as of the date of
purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above,
your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except
where prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product, whether direct, indirect,
special, incidental or consequential regardless of the legal theory asserted.
Electrical Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
www.3M.com/elpd
of knife or other sharp tools that could damage cables.)
Mastic and Vinyl Tape Seal from cables.
(CAUTION: Be careful not to damage cables.)
motor lead from the feeder cable(s).
Printed on 50% recycled paper
with 10% post-consumer
Appendix B
Splice Reusability
1. First inspect the removed Lug Cover for damage or
2. Obtain material to replace the non-reusable splice
3. Re-Install the splice according to the standard kit
Reusable Component
Replacement Components
wear. Replace it with a new splice if evidence of
damage or wear is found.
components.
instructions.
• Lug Cover
These are standard 3M products, available from 3M
Electrical Products Division.
• Scotch-Seal
• 3M
• Scotch
• 3M
41813), 5/8" x 6", 40/case
5 cc Tube
(UPC 054007-06132), 3/4" x 66'
(78-8041-7208-4, special order)
™
™
Pin-Lug Cover, 2” Lg.
SIL-5cc Silicone Grease (UPC 054007-41814),
®
‚ Super 33+ Vinyl Electrical Tape
™
2230 Mastic Strip (UPC 054007-
©3M 2002 78-8126-0998-6-A
Litho in USA