SP4-L2-DC12V PANASONIC EW, SP4-L2-DC12V Datasheet - Page 7

• Manufacturer Part Number: SP4-L2-DC12V
• Description: POWER RELAY, 12VDC, 10A, 4PDT, PLUG-IN
• Manufacturer: PANASONIC EW

Specifications of SP4-L2-DC12V

• Relay Type: Polarized
• Coil Voltage Vdc Nom: 12V
• Contact Current Max: 10A
• Contact Voltage Ac Nom: 250V
• Contact Voltage Dc Nom: 30V
• Coil Resistance: 480ohm
• Contact Configuration: 4PDT
• Coil Type: DC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DIMENSIONS
ds_61A08_en_sp: 300108D
Use method
1. Both the SP relay 2 Form C and
4 Form C can be mounted to the
mounting slats.
2. Use the mounting slats either by
attaching them directly to the chassis, or
by mounting with a DIN rail.
(A) When attaching directly to chassis
Use two M3 screws.
For the mounting pitch, refer to the
specification diagram.
(B) When mounting on a DIN rail
Use a 35mm
(DIN46277).
The mounting method should be as
indicated in the diagram at right.
18.4
.724
1.378inch
2.252
57.2
(Unit: mm inch)
wide DIN rail
.984
23.2
.913
25
Mounting hole diagram
Method for mounting on DIN rail
Fit into mounting
grooves.
Part No.: SP-MA
Press
Panel cutout
ACCESSORIES
18.4
.724
Press relay in
Tolerance: 0.1
Fit in
2-3.2 dia. hole
2-.126 dia. hole
To remove the
relay, press down
the mounting slats
so the claws move
to the outside.
Mounting
slat
DIN rail
.004
Fig. 1
Fig. 2
Fig. 3
Direct chassis mounting possible, and applicable to DIN rail.
(1) First fit the arc shaped claw of the
mounting slat into the DIN rail.
(2) Press on the side as shown in the
diagram below.
(3) Fit in the claw part on the opposite
side.
Precautions for use
When mounting to a DIN rail, use a
commercially available fastening bracket
if there is a need to stop sliding of the
mounting slat in the rail direction.
MOUNTING BOARD
SP RELAYS
SP
7