A165E-M-02 Omron, A165E-M-02 Datasheet - Page 202

• Manufacturer Part Number: A165E-M-02
• Description: SWITCH, EMERGENCY STOP, DPST-NC, 250VAC
• Manufacturer: Omron
• Series: A165Er

Specifications of A165E-M-02

• Contact Configuration: DPST-NC
• Switch Operation: Pushlock Turn Reset
• Contact Voltage Ac Nom: 250V
• Contact Voltage Dc Nom: 30V
• Contact Current Max: 5A
• Actuator Style: Round
• Switch Terminals: Solder
• Actuator Length: 20mm
• Ip Rating: IP65
• Pole Throw Configuration: DPST
• Switch Function Configuration: N.C.
• Current Rating (max): 5A
• Operating Temp Range: -10C to 55C
• Contact Form: DPST - NC
• Actuator Diameter: 40mm
• Svhc: No SVHC
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Installing the Switch Blocks
Hook the small protrusion on the Mounting Latch into the groove on
the other side of the lever, then push up the Switch Block in the direc-
tion indicated by the arrow in the figure below.
Removing the Switch Blocks
Insert a screwdriver between the Mounting Latch and the Switch
Block, then push down the screwdriver in the direction indicated by
the arrow in the following figure.
200
Installing/Removing the Switch
Blocks
Mounting
Latch
Flat-head
screwdriver
Phillips
screwdriver
Use either of the following screwdrivers.
3 to 6 mm dia.
3 to 6 mm
Switch Block
Screwdriver
Protrusion
Lever
Wiring Round Crimp Terminals
Loosen the terminal screw from the Switch Unit until it completely
comes off the groove, insert a screwdriver as shown in the following
figure, then push up the washer in the direction indicated by the
arrow to temporarily secure it. Now, a round crimp terminal can be
connected. After inserting the terminal, tighten the screws to com-
plete wiring.
Wiring
Washer
Screw
Screwdriver