QS30EDV BANNER ENGINEERING, QS30EDV Datasheet - Page 2

• Manufacturer Part Number: QS30EDV
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING
• Type: Diffuser

Specifications of QS30EDV

• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Sensor Housing: Rectangular
• Sensing Range Min: 1100mm
• Sensor Input: Optical
• Body Material: ABS Plastic
• Supply Voltage Max: 30VDC
• Brand/series: World-Beam®
• Current, Switching: 150 mA
• Function: Proximity
• Ip Rating: IP67
• Mounting Type: Threaded
• Output: NPN/PNP
• Primary Type: Photoelectric
• Range, Measurement: 1100 mm
• Sensing Mode: Diffuse
• Technology: Photoelectric
• Termination: 5-Wire Cable
• Voltage, Supply: 30 VDC

The QS30EDV is an easy-to-use diffuse-mode sensor. It provides high-performance
sensing in low-contrast applications. Its visible red beam provides easy sensor alignment.
The sensor offers multiple configuration options, in addition to manual fine adjustment,
remote programming, and security lockout options.
The sensor features bipolar outputs, one each NPN and PNP.
The sensor’s compact housing has a large, easy-to-see bargraph display plus bright LEDs
for easy configuration and status monitoring during operation. LEDs # 1–4 of the bargraph
display also show configuration status during SETUP. The sensor can be side-mounted,
using its integral mounting holes, or front-mounted, via its 30 mm threaded barrel.
Sensor configuration is accomplished through TEACH or SET options, plus SETUP mode.
After TEACH or SET have defined the sensing parameters, SETUP mode may be used to
enable the delay, to change the Light Operate/Dark Operate status, or to select the high-
speed response option (HS). Manual Adjust may be used to fine-tune the thresholds (see
page 9). Two push buttons, Dynamic (+) and Static (-), or the remote wire, may be used
to access and set the parameters.
Sensor configuration options include:
• Two-Point Static TEACH: a single switching threshold, determined by two taught
• Dynamic (on-the-fly) TEACH: a single switching threshold, determined by multiple
• Window SET: a sensing window, centered on a single sensing condition
• Light SET and Dark SET: a single switching threshold, offset from a single sensing
Remote Configuration
The remote function may be used to configure the sensor remotely or to disable the
push buttons for security. Connect the gray wire of the sensor to ground (0V dc), with a
remote programming switch connected between them. Pulse the remote line according to
the diagrams in the configuration procedures. The length of the individual programming
pulses is equal to the value T:
Returning to RUN Mode
Configuration modes each may be exited either after the 60-second time-out, or by exiting
the process:
• In static TEACH or SET modes, press and hold the Static (-) button (or hold the remote
• In SETUP mode, press and hold both the Static (-) and Dynamic (+) buttons (or hold
WORLD-BEAM
2
conditions
sampled conditions
condition
line) for 2 seconds. The sensor returns to RUN mode without saving any new settings.
the remote line) for 2 seconds. The sensor returns to RUN mode and saves the current
setting.
P/N 127755 rev. B
0.04 seconds ≤ T ≤ 0.8 seconds
®
Sensor Configuration
QS30EDV
Overview
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]
Figure 1. Features
LEDs #1–4 Also Display
Configuration Status
Bargraph Display
Green Power ON LED
Configuration
Push Buttons
Yellow Output LED
Threshold
Switching
(Red)