72-8355 TENMA, 72-8355 Datasheet - Page 3

• Manufacturer Part Number: 72-8355
• Description: POWER SUPPLY, SWITCH MODE, 16V
• Manufacturer: TENMA

Specifications of 72-8355

• Power Supply Output Type: Variable
• No. Of Outputs: 1
• Output Voltage: 16V
• Output Current: 5A
• Power Rating: 80W
• Input Voltage: 90V AC To 264V AC
• Length: 330.2mm
• Width: 50.8mm
• Height: 127mm
• Weight: 4.2lb

Keep this manual in a safe place for quick reference at all times.
This manual contains important safety and operation instructions
for correct use of the power supply. Read through the manual and pay special
attention to the markings and labels of this unit and equipment to be connected.
Pay special attention to these two types of notices used in this manual.
Failure to observe this warning may cause injury to persons and damage to power supply or
connected equipment
Failure to observe this warning may result in damage to equipment and improper functioning of
the power supply.
WARNING:
CAUTION:
Environmental condition requirements:
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
Do not use this power supply near water.
Do not operate or touch this power supply with wet hands.
Do not open the casing of the power supply when it is connected to AC power source.
Refer all servicing to qualified service personnel only.
Before replacing the AC fuse first determine and correct the cause or the blown fuse.
Replace the AC fuse with the same type and rating as the original fuse.
Use only a properly grounded AC power source.
This unit is for indoor use only.
Do not operate or place this unit in a humid or dusty environment, in direct sunlight or
near any heat source.
Before plugging into AC power source, check with the rating label at the back of the
unit.
Do not block ventilation openings on the unit.
This unit must be used within the specified rating. Continuous excessive loading may
cause damage to the power supply.
The AC power cord must be at least 18AWG, and not exceed 3m in length.
Replacement fuse: T3AL250V (3A Time-Lag)
10-80% R.H.
Altitude up to 2000m
Installation category: CAT 2
Pollution degree: 2
Maximum supply voltage fluctuation: ±10% of specified operating voltage.
WARNING
CAUTION
3