72-8355 TENMA, 72-8355 Datasheet - Page 6

• Manufacturer Part Number: 72-8355
• Description: POWER SUPPLY, SWITCH MODE, 16V
• Manufacturer: TENMA

Specifications of 72-8355

• Power Supply Output Type: Variable
• No. Of Outputs: 1
• Output Voltage: 16V
• Output Current: 5A
• Power Rating: 80W
• Input Voltage: 90V AC To 264V AC
• Length: 330.2mm
• Width: 50.8mm
• Height: 127mm
• Weight: 4.2lb

Operation
1. Stand Alone Operation
2. Selection of Voltage and Current Range at (8)
3. Viewing Settings
4. Setting the Current Limiting Value
•
•
•
•
•
•
•
•
•
•
Make certain that the power supply is set for MASTER operation. To do this, maker sure
the MASTER/SLAVE selector on the rear panel (17) set to MASTER position. All
controls will function as with any a normal power supply.
With no load connected to the power supply, turn the power supply ON via the POWER
switch on the front panel (1). The LED display should light up, however there will not be
any reading on the voltmeter or ammeter.
Press the OUTPUT ON button (9), its green LED will light up and the voltmeter will
display the set output voltage.
Take note of the preset RANGE (8) by which LED is illuminated. Adjust the VOLT
control (5) and note the effect on displayed voltage on the LED display.
The three buttons in the RANGE panel (8) will determine the voltage and current range
available from the supply. Depress the corresponding button to place the power supply in
the desired range. The appropriate LED will illuminate to show which range the supply
is in.
Note: To protect the connected load, the OUTPUT (9) will return to OFF status any time
the output RANGE (8) is changed. The Volt and Amp display will return to zero.
The REVIEW button (7) allows you to check voltage and current limiting settings of the
power supply while the OUTPUT (9) is turned off, or when no load is connected. This is
especially helpful since conventional power supplies require the connection of some type
of load to view the current limit setting.
To operate, press and hold the REVIEW button (7) to display voltage and current
limiting values. Note this is a momentary pushbutton and will only display the settings
while depressed.
Press and hold the PREVIEW button (7)
Turn the CURR current adjustment (5) to our desired current limit value
6