ACPM-7372-TR1 Avago Technologies US Inc., ACPM-7372-TR1 Datasheet - Page 12

• Manufacturer Part Number: ACPM-7372-TR1
• Description: 4x4mm UMTS PA Module For Band 8
• Manufacturer: Avago Technologies US Inc.
• Type: Power Amplifierr

Specifications of ACPM-7372-TR1

• Current - Supply: 560mA
• Frequency: 880MHz ~ 915MHz
• Gain: 27dB
• Package / Case: 10-SMD Module
• Rf Type: W-CDMA
• Voltage - Supply: 3.2V ~ 4.2V
• Number Of Channels: 1
• Frequency (max): 915MHz
• Power Supply Requirement: Dual
• Single Supply Voltage (min): Not RequiredV
• Single Supply Voltage (typ): Not RequiredV
• Single Supply Voltage (max): Not RequiredV
• Package Type: SMD
• Dual Supply Voltage (typ): 3.4V
• Dual Supply Voltage (max): 4.2V
• Operating Temperature Classification: Commercial
• Operating Temp Range: -20C to 85C
• Pin Count: 10
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Noise Figure: -
• P1db: -
• Test Frequency: -
• Lead Free Status / Rohs Status: Compliant

Handling and Storage
ESD (Electrostatic Discharge)
Electrostatic discharge occurs naturally in the environ-
ment. With the increase in voltage potential, the outlet of
neutralization or discharge will be sought. If the acquired
discharge route is through a semiconductor device, de-
structive damage will result.
ESD countermeasure methods should be developed and
used to control potential ESD damage during handling in
a factory environment at each manufacturing site.
MSL (Moisture Sensitivity Level)
Plastic encapsulated surface mount package is sensitive to
damage induced by absorbed moisture and temperature.
Avago Technologies follows JEDEC Standard J-STD 020B.
Each component and package type is classified for
moisture sensitivity by soaking a known dry package at
various temperatures and relative humidity, and times.
After soak, the components are subjected to three con-
secutive simulated reflows.
Moisture Classification Level and Floor Life
Note :
1. The MS� �evel is marked on the MS� �abel on each shipping bag.
12
MS� �evel
1
2
2a
3
4
5
5a
6
��loor �ife (out of bag) at factory ambient = < 30°C/60% �H or as stated
Unlimited at = < 30°C/85% �H
1 year
4 weeks
168 hours
72 hours
48 hours
24 hours
Mandatory bake before use. After bake, must be reflowed within the time limit specified on the label
The out of bag exposure time maximum limits are de-
termined by the classification test describe below which
corresponds to a MS� classification level 6 to 1 according
to the JEDEC standard IPC/JEDEC J-STD-020B and J-STD-
033.
ACPM-7372 is MS�3. Thus, according to the J-STD-033
p.11 the maximum Manufacturers Exposure Time (MET)
for this part is 168 hours. After this time period, the part
would need to be removed from the reel, de-taped and
then re-baked. MS� classification reflow temperature for
the ACPM-7372 is targeted at 260°C +0/-5°C. ��igure and
table on next page show typical SMT profile for maximum
temperature of 260 +0/-5°C.