AFCT-701SDDZ Avago Technologies US Inc., AFCT-701SDDZ Datasheet - Page 3
![no-image](/images/manufacturer_photos/0/0/86/avago_technologies_us_inc__sml.jpg)
AFCT-701SDDZ
Manufacturer Part Number
AFCT-701SDDZ
Description
10G/1G Dual Data Rate SFP+LR,RoHS
Manufacturer
Avago Technologies US Inc.
Datasheet
1.AFCT-701SDDZ.pdf
(20 pages)
Specifications of AFCT-701SDDZ
Data Rate
10.312Gbd
Wavelength
1310nm
Applications
Ethernet
Voltage - Supply
3.135 V ~ 3.465 V
Connector Type
LC Duplex
Mounting Type
SFP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Transmitter Section
The transmitter section includes the Transmitter Optical
Sub-Assembly (TOSA) and laser driver circuitry. The
TOSA, containing an Avago designed and manufactured
1310 nm DFB light source, is located at the optical inter-
face and mates with the LC optical connector. The TOSA
is driven by an IC which uses the incoming differential
high speed logic signal to modulate the laser diode
driver current. This Tx laser driver circuit regulates the
optical power at a level within the specified range.
Transmit Disable (TX_DISABLE)
The AFCT-701SDDZ accepts an LVTTL compatible trans-
mit disable control signal input which shuts down the
transmitter optical output. A high signal implements
this function while a low signal allows normal transceiver
operation. In the event of a fault (e.g. eye safety circuit
activated), cycling this control signal resets the module
as depicted in Figure 5. An internal pull up resistor dis-
ables the transceiver transmitter until the host pulls the
input low. TX_DISABLE can also be asserted via the two-
wire interface (address A2h, byte 110, bit 6) and moni-
tored (address A2h, byte 110, bit 7).
The contents of A2h, byte 110, bit 6 are logic OR’d with
hardware TX_DISABLE (contact 3) to control transmitter
operation. The normal behavior of this feature is to reset
a TX disabled transceiver to TX enabled when it is power
cycled or hot-plugged.
Figure 1. Transceiver functional diagram
3
OPTICAL INTERFACE
LIGHT FROM FIBER
LIGHT TO FIBER
RECEIVER
TRANSMITTER
PHOTO-DETECTOR
VCSEL
CONTROLLER & MEMORY
AMPLIFICATION
& QUANTIZATION
Transmit Fault (TX_FAULT)
A catastrophic laser fault will activate the transmitter
signal, TX_FAULT, and disable the laser. This signal is
an open collector output (pull-up required on the host
board). A low signal indicates normal laser operation and
a high signal indicates a fault. A fault is defined as laser
power below or above the specified IEEE 802.3ae speci-
fied min/max range. The TX_FAULT will be latched high
when a laser fault occurs and is cleared by toggling the
TX_DISABLE input or power cycling the transceiver. The
transmitter fault condition can also be monitored via the
two-wire serial interface (address A2, byte 110, bit 2).
CIRCUITRY
DRIVER &
SAFETY
LASER
RD+ (RECEIVE DATA)
RD– (RECEIVE DATA)
RX_LOS
RS0
RS1
SDA
SCL
MOD-ABS
TX_DISABLE
TD+ (TRANSMIT DATA)
TD– (TRANSMIT DATA)
TX_FAULT
ELECTRICAL INTERFACE