50669 EMIT, 50669 Datasheet - Page 3

• Manufacturer Part Number: 50669
• Description: Infrared Remote Control
• Manufacturer: EMIT

Specifications of 50669

• Width: 2.75"
• Ionizer Type: Hand Held
• Height: 4.94"
• Depth: 0.94"
• Features: Power Input
• Operating Distance: 0 To 10 Ft Min.
• 8x2 Lcd Display: RoHS Compliant
• For Use With: Desco 50665 & 50664 Overhead Ionizers

TB-6539 Page 3 of 4
O n
n n n n
◄▼▲►
50669
UNIT ID:
123 SET
The
remote turns itself off while the
and the address re-entered to continue with programming.
To enable / disable the buttons on the
following procedure. (Note: the
for these commands.)
50669
UNIT ID:
123 SET
BUTTONS
123
50665
O F F b
n n n n
◄▼▲►
50669
STANDBY
123
50665
1 2 3 S
n n n n
◄▼▲►
50669
b
will turn itself off automatically after 1 minute of inactivity (no buttons pressed). If the
(Note: “OFF b” is a feature that can only be activated by the
control and button status is explained later.)
To reset the remote control address ID, press and hold the ► button until the
cursor is present over the third address digit. Repeat setup mode procedure for
multiple
EMIT - 3651 Walnut Avenue, Chino, CA 91710 • [phone] • Fax [phone] • Website:
This means that the buttons on the
used. If the user attempts to go into the ionizer setup mode by pressing ◄
and ► buttons simultaneously on the 50665, the unit will display
“OFF b”. Pressing ▼ and ▲ buttons simultaneously again on the remote, will
simultaneously on the remote will disable the buttons on the 50665. The
With the cursor on the first digit, press the ◄ button on the remote to go to
will display “SAVE” followed by “OFF b” for “off buttons”.
enable the buttons. The
“On b” for “on buttons”.
On the remote control, select the address of the
controlled.
the enable / disable Buttons Screen. Pressing ▼ and ▲buttons
Press the ◄ button on the remote to go to the standby screen. Pressing ▼
and ▲ buttons simultaneously on the remote will put the
simultaneously on the remote once more will restart the unit.
mode. The
followed by an “S” for “standby”, “123S”. The unit will be powered down
thereby shutting off the fans and ionizing circuitry. Pressing ▼ and ▲
50665
units. (Note: the remote can only program one unit at a time.)
50665
50665
50665
will display “Stby” momentarily, then display its address
is in the program mode, the
50665
must be in normal operating mode, not the setup mode
50665
or to put the unit into standby mode, use the
will display “SAVE” followed by
50665
will not be able to be
50669
50665
DescoEMIT.com
must be turned back on
unit to be
50665
50669
into standby
remote
© 2009 DESCO INDUSTRIES INC.
50665
Employee Owned