DK-START-4CGX15N/P Altera, DK-START-4CGX15N/P Datasheet - Page 12

• Manufacturer Part Number: DK-START-4CGX15N/P
• Description: Cyclone IV Tranceiver Development Kit
• Manufacturer: Altera

Specifications of DK-START-4CGX15N/P

• Silicon Manufacturer: Altera
• Features: System Controller Enabling Passive Serial, Flash/SRAM Memory Devices, PCI Express Edge Connector
• Kit Contents: Board, Cables, PSU, CD
• Core Architecture: FPGA
• Core Sub-architecture: Cyclone
• Silicon Core Number: EP4C
• Silicon Family Name: Cyclone IV GX
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2–4
Table 2–1. Cyclone IV GX Transceiver Starter Board Components (Part 3 of 3)
Featured Device: Cyclone IV GX Device
Table 2–2. Cyclone IV GX EP4CGX15BF14 Device Features
Table 2–3. Cyclone IV GX Device Component Reference and Manufacturing Information
Cyclone IV GX Transceiver Starter Board Reference Manual
J8, J9
J10, J11
C57, C58, C59,
C60
R51, R52, R53,
R54
Power Supply
J4
SW1
Board Reference
Board Reference
Equivalent LEs
14,400
U8
f
Transceiver RX SMA connectors Two input SMAs (optional) to the high-speed positive and negative
Transceiver TX SMA connectors Two output SMAs (optional) from the high-speed positive and
Transceiver RX capacitor
multiplexer
Transceiver TX resistor
multiplexer
DC input jack
Power switch
M9K RAM Blocks
FPGA, Cyclone IV GX,
169-pin FBGA package, 14K
LEs, lead-free
The Cyclone IV GX Transceiver starter board features the Cyclone IV GX
EP4CGX15BF14 device (U8) in a 169-pin FBGA package.
For more information about Cyclone IV device family, refer to the
Handbook.
Table 2–2
Table 2–3
information.
(Kbits)
9
Description
Type
describes the features of the Cyclone IV GX EP4CGX15BF14 device.
lists the Cyclone IV GX device component reference and manufacturing
Memory (Kbits)
Embedded
540
Altera Corporation
differential receiver channel. These connectors cannot be used
together with the Gigabit Ethernet port.
negative differential transmitter channel. These connectors cannot be
used together with the Gigabit Ethernet port.
Capacitor multiplexer which requires a minor modification on the
board if the optional transceiver RX SMA connectors (J8, J9) are
used.
Resistor multiplexer which requires a minor modification on the
board if the optional transceiver TX SMA connectors (J11, J10) are
used.
Accepts a 9-V – 16-V DC power supply. Do not use this input jack
while the board is plugged into a PCI Express slot.
Switch to power on or off the board when power is supplied from the
DC input jack.
Manufacturer
18-bit × 18-bit
Multipliers
0
Transceivers
EP4CGX15BF14
(2.5 Gbps)
Manufacturing
Part Number
Description
2
Featured Device: Cyclone IV GX Device
© March 2010 Altera Corporation
PLLs
Chapter 2: Board Components
3
Cyclone IV Device
www.altera.com
Manufacturer
Package Type
169-pin FBGA
Website