USB-2-X V2 TRINAMIC, USB-2-X V2 Datasheet - Page 6

• Manufacturer Part Number: USB-2-X V2
• Description: USB TO SERIAL ADAPTOR
• Manufacturer: TRINAMIC
• Type: USB To Serial Adapterr

Specifications of USB-2-X V2

• Kit Features: Equipped With CAN, I2C, SIP And LIN Interfaces
• Development Tool Type: Hardware / Software - Adapter
• Tool / Board Application: USB To Serial Adapter
• Convert From: USB
• Convert To: Serial Adaptor
• Svhc: No SVHC (15-Dec-2010)
• Ic Adapter Type: USB To Serial Adapter
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6
2.3.4 IIC
2.3.5 SPI
2.3.6 RS485
2.3.7 Housing
Single master
Up to 400kBit/s
7-bit addressing
Four standard signals: SCK, MOSI, MISO, SS (SlaveSelect)
Also usable as JTAG interface: TCK, TDO, TDI, TMS (supported in future firmware revisions)
Additional 5
Software selectable signal levels: 5V or 3.3V
Master mode operation
Silent slave mode (spy mode) possible when MISO is not connected to the target
Clock phase and polarity: all four modes software selectable
Setup and hold time of slave select signal as well as inter-byte delay time software selectable
Data rates: up to 3.75 Mbit/s at 5V, up to 1.5 Mbit/s at 3.3V
Half duplex communication mode
Industry standard 75176 transceiver
2400, 9600 and 19200 bps supported
Pull-up resistor, pull-down resistor and termination resistor possible (assembly option on request)
Compact, metalized standard housing (know as 25 pin Sub-D adapter housing)
Dimensions: 62.5mm x 54.4mm x 16.9mm (length x width x height)
th
line SR: slave request signal input (falling edge active, internal pull-up)
USB2X Interface Converter
Trinamic Motion Control GmbH & Co KG
D – 20357 Hamburg, Germany
Phone [phone] - 0
FAX: [phone] - 60
http://www.trinamic.com
Sternstraße 67