1954381-1 TE Connectivity, 1954381-1 Datasheet - Page 30

• Manufacturer Part Number: 1954381-1
• Description: GROUNDING CLIP, 12-10 AWG GROUND WIRE
• Manufacturer: TE Connectivity
• Type: Grounding Clipr
• Series: SOLARLOKr

Specifications of 1954381-1

• Product Length (mm): 20mm
• Product Depth (mm): 32.5mm
• Product Height (mm): 24.5mm
• Accessory Type: Grounding Clip
• Rohs Compliant: Yes
• Product Type: Accessory
• Screw Size: 10-32 Thread Cutting
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Lead Free Status / RoHS Status: Compliant
• For Use With: 12-10 AWG Solid Un-Insulated Ground Wire
• Lead Free Status / Rohs Status: RoHS Compliant part

28
tycoelectronics.com/solar
Catalog 3-1773458-6 | Issue Date 09/2010
3.2 Connector Latching
3.3 Disconnecting
SOLARLOK Connectivity Systems for PV Installers
Assembly and Installation Guidelines (continued)
When mating the SOLARLOK connectors, ensure the following:
1 : Connectors labeled with a plus or minus are keyed and can only be mated to
similarly marked and keyed connectors.
CAUTION : THE “NEUTRAL” DESIGNATED PIN CONNECTORS INCORPORATE
NO KEYING FEATURES AND MUST ONLY BE USED FOR SERIAL INTERCONNECTION
OF PHOTOVOLTAIC MODULES. THE NEUTRAL PRODUCT SHOULD NOT BE USED
WHERE MAINTAINING POLARITY IS CRITICAL.
2 : The polarity of the “neutral” connector should be labeled with
part number : 1394725-1 or 1394725-2.
3 : The connector system is fully latched only when the latches are flush with the
mating connectors. After the connector is fully latched, the optional latch locking
clip may be snapped into place.
CAUTION : DO NOT DISCONNECTED UNDER LOAD.
Disconnect circuit load before unplugging connectors by using approved devices
(DC main switch, inverter connector and other devices). Cable assemblies should
be labeled with part number : 1394470-1.
1 : The locking mechanism is opened by depressing the latches.
2 : Pull out the connectors. While depressing the latches, disconnect the
connector by pulling the connector halves apart.
Dimensions are in inches and millimeters unless otherwise specified.
Values in brackets are standard equivalents. Dimensions are shown
for reference purposes only. Specifications subject to change.
USA: 1-800-522-6752
Canada: [phone]
Mexico/C. Am.: [phone]
South America: [phone]
(female connector)
Germany: [phone]
UK: [phone]
France: [phone]
China: [phone]
Fig. 6
Fig. 5