2222 338 24684 Vishay, 2222 338 24684 Datasheet - Page 17

• Manufacturer Part Number: 2222 338 24684
• Manufacturer: Vishay

Specifications of 2222 338 24684

• Tolerance (+ Or -): 20%
• Voltage: 310VAC
• Temp Coeff (dielectric): PLYP
• Mounting Style: Through Hole
• Construction: Radial
• Failure Rate: Not Required
• Seated Plane Height: 18mm
• Product Diameter (mm): Not Requiredmm
• Product Height (mm): 18mm
• Product Depth (mm): 8.5mm
• Product Length (mm): 26mm
• Lead Spacing (nom): 22.5mm
• Lead Diameter (nom): 0.8mm
• Operating Temp Range: -55C to 110C
• Capacitance: .68uF
• Package / Case: Not Required
• Lead Free Status / RoHS Status: Compliant

www.vishay.com
161
MKP 338 2 X2
Vishay BCcomponents
SUB-CLAUSE NUMBER AND
TEST
4.12.3 Final measurements
SUB-GROUP C3
4.13.1 Initial measurements
4.13
4.14
4.14.7 Final measurements
Impulse voltage
Endurance
CONDITIONS
Visual examination
Capacitance
Tangent of loss angle
Voltage proof
1350 Vdc; 1 min between term.
Insulation resistance
Capacitance
Tangent of loss angle:
3 successive impulses, full wave, peak voltage:
X2: 2.5 kV for C ≤ 1 µF
X2: 2.5 kV/√C for C > 1 µF
Max.24 pulses
Duration: 1000 h
1.25 x U
Once in every hour the voltage is increased to
1000 V (RMS) for 0.1 s via resistor of 47 Ω ± 5 %
Visual examination
Capacitance
Tangent of loss angle
Voltage proof
Insulation resistance
Interference Suppression Film Capacitors
For C ≤ 1 µF at 10 kHz
For C > 1 µF at 1 kHz
1350 Vdc; 1 min between
terminations.
2120 Vac; 1 min between
terminations and case.
For technical questions, contact:
Rac
at 110 °C
MKP Radial Potted Type
[e-mail]
PERFORMANCE REQUIREMENTS
No visible damage
Legible marking
¦ΔC/C¦ ≤ 5 % of the value measured in 4.12.1.
Increase of tan δ:
≤ 0. 008 for: C ≤ 1 µF or
≤ 0. 005 for: C > 1 µF
Compared to values measured in 4.12.1.
No permanent breakdown or flash-over
≥ 50 % of values specified in section “Insulation
Resistance” of this specification
No selfhealing breakdowns or flashover
No visible damage
Legible marking
¦ΔC/C¦ ≤ 10 % compared to values measured in
4.13.1.
Increase of tan δ:
≤ 0.008 for: C ≤ 1 µF or
≤ 0.005 for: C > 1 µF
Compared to values measured in 4.13.1.
No permanent breakdown or flash-over
≥ 50 % of values specified in section “Insulation
Resistance” of this specification
Document Number: 28119
Revision: 16-Jul-09