UDS100-B Lantronix, UDS100-B Datasheet - Page 41

• Manufacturer Part Number: UDS100-B
• Description: Ethernet Modules & Development Tools Single Port
• Manufacturer: Lantronix
• Type: Serial to Ethernetr

Specifications of UDS100-B

• Data Rate: 300 bps to 115.2 Kbps
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

UDS10/UDS100 User Guide
The unit performs a power reset after the firmware has been loaded and stored.
Using Another Unit
To distribute firmware to another unit over the network:
1. Enter the host unit's Monitor Mode (see
2. Send the firmware to the receiving unit using the SF command, where x.x.x.x is
The receiving unit performs a power reset after the firmware has been loaded and
stored.
Note:
DeviceInstaller.
Using the Serial Port
The following procedure is for using the HyperTerminal software application. This
procedure takes about 10 minutes.
Warning:
of power while reprogramming will result in a corrupt program image
and a nonfunctional unit.
To download firmware from a computer using the unit’s serial port:
1. Enter Monitor Mode using the serial port (see
the receiving unit's IP address.
Serial Port
You can only update the unit’s internal web interface using TFTP or
Do not switch off the power supply during the update. A loss
on page 43).
Figure 6-2. Sending Firmware to Another Unit
Figure 6-1. TFTP Dialog Box
SF x.x.x.x
41
7: Using Monitor Mode).
Entering Monitor Mode Using the
Updating Firmware