DLP-RF1-Z DLP Design Inc, DLP-RF1-Z Datasheet - Page 9

• Manufacturer Part Number: DLP-RF1-Z
• Description: Zigbee / 802.15.4 Modules & Development Tools PC INTERFACE HOST MODULE (USB)
• Manufacturer: DLP Design Inc

Specifications of DLP-RF1-Z

• Wireless Frequency: 2.4 GHz
• Interface Type: USB
• Operating Voltage: 9 V
• Antenna: Integral to PCB Design?No External
• For Use With/related Products: MC13193, MC9S08GT60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.0 Regulatory Agency Considerations
4.1 Agency Identification Numbers
Compliance with the appropriate regulatory agencies is essential in the deployment of all transceiver
devices. DLP Design has obtained modular approval for this RF product such that an OEM need only
meet a few basic requirements in order to utilize their end product under this approval. Corresponding
agency identification numbers are listed here:
4.2 Integral Antenna
The DLP-RF1 is approved for use with the integral antenna only. Modifying the DLP-RF1’s PCB antenna
or modifying the PCB to use an external antenna will void all agency compliance.
4.3 FCC/IC Requirements for Modular Approval
Any changes or modifications to the DLP-RF2’s printed circuit board could void the user’s authority to
operate the equipment.
4.3.1 Warnings
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesirable operation.
This device is intended for use under the following conditions:
1. The transmitter module may not be co-located with any other transmitter or antenna.
2. The module is approved using the FCC “unlicensed modular transmitter approval” method.
As long as these two conditions are met, further transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their end product for any additional compliance measures
necessitated by the installation of this module (i.e. digital device emissions, PC peripheral requirements,
etc.).
Note: In the event that these conditions cannot be met (i.e. co-location with another transmitter), then
the FCC authorization is no longer valid and the corresponding FCC ID may not be used on the final
product. Under these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
Rev 1.5 (November 2005)
Part Number
DLP RF1
US/FCC
SX9000RF1
9
CAN/IC
5675A-000RF1
DLP-RF1/Z DLP Design, Inc.