ZFSM-201-1-B CEL, ZFSM-201-1-B Datasheet - Page 15
![Zigbee / 802.15.4 Modules & Development Tools Freestar Pro Module 100mW PCB Trace Ant](/photos/26/96/269657/zfsm-201_sml.jpg)
ZFSM-201-1-B
Manufacturer Part Number
ZFSM-201-1-B
Description
Zigbee / 802.15.4 Modules & Development Tools Freestar Pro Module 100mW PCB Trace Ant
Manufacturer
CEL
Datasheet
1.ZFSM-201-1.pdf
(17 pages)
Specifications of ZFSM-201-1-B
Wireless Frequency
2400 MHz to 2483.5 MHz
Security
AES
Operating Voltage
- 0.3 V to + 3.6 V
Output Power
100 mW
Antenna
PCB Trace
Operating Temperature Range
- 45 C to + 125 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
AGENCY CERTIFICATIONS
IC Certification — Industry Canada Statement
The term "IC" before the certification / registration number only signifies that the Industry Canada technical specifications
were met.
Section 14 of RSS-210
The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in
excess of Health Canada limits for the general population. Consult Safety Code 6, obtainable from Health Canada's
website:
CE Certification — Europe
The FreeStar Pro RF module has been tested and certified for use in the European Union.
OEM Responsibility to the European Union Compliance Rules
If the FreeStar Pro module is to be incorporated into a product, the OEM must verify compliance of the final product to the
European Harmonized EMC and Low-Voltage / Safety Standards. A Declaration of Conformity must be issued for each of
these standards and kept on file as described in Annex II of the R&TTE Directive.
The manufacturer must maintain the user's guide and adhere to the settings described in the manual for maintaining
European Union Compliance. If any of the specifications are exceeded in the final product, the OEM is required to
make a submission to the notified body for compliance testing.
OEM Labeling Requirements
The `CE' mark must be placed on the OEM product in a visible location.
The CE mark shall consist of the initials “CE” with the following form:
· If the CE marking is reduced or enlarged, the proportions given in the above graduated
· The CE mark must be a minimum of 5mm in height
· The CE marking must be affixed visibly, legibly, and indelibly Since the 2400 - 2483.5 MHz
drawing must be adhered to.
band is not harmonized by a few countries throughout Europe, the Restriction sign must be
placed to the right of the `CE' marking as shown in the picture
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/99ehd-dhm237/index-eng.php
(Continued)
Page 15
ZFSM-201 Series