AD8074ARU Analog Devices Inc, AD8074ARU Datasheet - Page 10

• Manufacturer Part Number: AD8074ARU
• Description: Buffer Amplifier IC
• Manufacturer: Analog Devices Inc

Specifications of AD8074ARU

• No. Of Amplifiers: 3
• Bandwidth: 600MHz
• Slew Rate: 1600V/µs
• No. Of Pins: 16
• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Rohs Status: RoHS non-compliant
• Applications: Buffer
• Number Of Circuits: 3
• -3db Bandwidth: 600MHz
• Current - Supply: 21.5mA
• Current - Output / Channel: 70mA
• Voltage - Supply, Single/dual (±): 9 V ~ 11 V, ±4.5 V ~ 5.5 V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With: AD8074Z-EVAL - BOARD EVAL FOR AD8074
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

AD8074/AD8075
RGB Buffer for Second Monitor
The RGB signals for PC monitors are driven through coax
cables whose characteristic impedance is 75 Ω. The graphics
chip will generally have current-source output drivers that should
be double terminated with a 75 Ω shunt termination at each end.
On the transmit end, the shunt terminations are provided to
ground close to the graphics IC, while the monitor terminates
its end via internal termination resistors. While this scheme works
well and is virtually foolproof for a single monitor, it leaves no
means for passively connecting a second monitor to the same source.
A second monitor that is connected simply in parallel will pro-
vide an extra set of terminations that will upset the signal levels.
To keep costs low, most computer monitors do not have the ability
to open-circuit the terminations in order that an additional monitor
CURRENT SOURCE
OUTPUT DRIVERS
PC GRAPHICS IC
R
G
B
75
75
75
25 F
+
+5V
25 F
+
0.1 F
–5V
+5V
0.1 F
0.1 F
AD8075
–5V
can be connected to the same signal, as is done in some studio-
type TV monitors.
A way around this problem is to connect the first monitor to the
RGB channels in the standard fashion, and then to provide a
triple gain-of-two buffer to drive the second monitor. The AD8075
is designed to provide this function and also provide excellent
high-frequency performance for high-resolution graphics signals.
Figure 3 shows a schematic of this circuit.
The outputs of the AD8075 are low impedance voltage sources
and are therefore series-terminated with 75 Ω resistors. The
internal resistors in Monitor #2 provide the terminations at its
end. The overall effect of this type of termination scheme is to
divide the signal amplitude by two. This is compensated by the
gain of two provided by the AD8075.
+5V
0.1 F
0.1 F
–5V
0.1 F
75
75
75
75
75
75
75
75
75
MONITOR #2
MONITOR #1
INTERNAL
TERMINATIONS
INTERNAL
TERMINATIONS