CS4245-DQZ Cirrus Logic Inc, CS4245-DQZ Datasheet - Page 35

• Manufacturer Part Number: CS4245-DQZ
• Description: IC,Soundcard Circuits,QFP,48PIN,PLASTIC
• Manufacturer: Cirrus Logic Inc
• Type: Stereo Audior

Specifications of CS4245-DQZ

• Data Interface: Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 2
• Sigma Delta: Yes
• Dynamic Range, Adcs / Dacs (db) Typ: 104 / 104
• Voltage - Supply, Analog: 3.13 V ~ 5.25 V
• Voltage - Supply, Digital: 3.13 V ~ 5.25 V
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1501 - BOARD EVAL FOR CS4245 CODEC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 598-1616

DS656F2
4.10
4.11
De-emphasis is only available in Single-Speed Mode.
Internal Digital Loopback
The CS4245 supports an internal digital loopback mode in which the output of the ADC is routed to the input
of the DAC. This mode may be activated by setting the LOOP bit in the Signal Selection register (See
tion 6.6 “Signal Selection - Address 06h” on page
ating at the same synchronous sample rate.
When this bit is set, the status of the DAC_DIF[1:0] bits in register 03h will be disregarded by the CS4245.
Any changes made to the DAC_DIF[1:0] bits while the LOOP bit is set will have no impact on operation until
the LOOP bit is cleared, at which time the Digital Interface Format of the DAC will operate according to the
format selected by the DAC_DIF[1:0] bits. While the LOOP bit is set, data will be present on the SDOUT pin
in the format selected by the ADC_DIF bit in register 04h.
Mute Control
The MUTEC pin becomes active during power-up initialization, reset, and muting if the MCLK2 to LRCK2
ratio is incorrect in Asynchronous Mode or the MCLK1 to LRCK2 ratio is incorrect in Synchronous Mode,
and during power-down. The MUTEC pin is intended to be used as control for an external mute circuit in
order to add off-chip mute capability.
Use of the Mute Control function is not mandatory, but recommended, for designs requiring the absolute
minimum in extraneous clicks and pops. Also, use of the Mute Control function can enable the system de-
-10dB
Gain
0dB
dB
Figure 15. De-Emphasis Curve
3.183 kHz
T1=50 µs
F1
45). To use this mode, the ADC and DAC must be oper-
10.61 kHz
F2
T2 = 15 µs
Frequency
CS4245
Sec-
35