ADNB-6032-EV Avago Technologies US Inc., ADNB-6032-EV Datasheet - Page 18
![OPT SENS BUNDLE W/A-6030 TL CLIP](/photos/26/56/265693/adnb-6032-ev_wht_sml.jpg)
ADNB-6032-EV
Manufacturer Part Number
ADNB-6032-EV
Description
OPT SENS BUNDLE W/A-6030 TL CLIP
Manufacturer
Avago Technologies US Inc.
Specifications of ADNB-6032-EV
Description/function
Laser Mouse Bundle
Interface Type
SPI
Product
Display Modules
Touch Panel
No Touch Panel
For Use With/related Products
ADNS-6030
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Required timing between Read and Write Commands
There are minimum timing requirements between read
and write commands on the serial port.
If the rising edge of the SCLK for the last data bit of the
second write command occurs before the required delay
(t
correctly.
If the rising edge of SCLK for the last address bit of the
read command occurs before the required delay (t
the write command may not complete correctly.
During a read operation SCLK should be delayed at least
t
ADNS-6030 has time to prepare the requested data. The
falling edge of SCLK for the first address bit of either the
read or write command must be at least t
after the last SCLK rising edge of the last data bit of the
previous read operation.
Figure 18. Timing between two write commands
Figure 19. Timing between write and read commands
Figure 20. Timing between read and either write or subsequent read commands
18
SCLK
SCLK
SCLK
SRAD
SWW
), then the first write command may not complete
after the last address data bit to ensure that the
Address
Address
Address
Write Operation
Write Operation
Data
Data
t
SRAD
Read Operation
SRR
or t
SWR
SRW
),
Address
Burst Mode Operation
Burst mode is a special serial port operation mode that
may be used to reduce the serial transaction time for a
motion read. The speed improvement is achieved by
continuous data clocking to or from multiple registers
without the need to specify the register address, and
by not requiring the normal delay period between data
bytes.
Burst mode is activated by reading the Motion_Burst
register. The ADNS-6030 will respond with the contents
of the Motion, Delta_X, Delta_Y, SQUAL, Shutter_Upper,
Shutter_Lower and Maximum_Pixel registers in that
order. The burst transaction can be terminated anywhere
in the sequence after the Delta_X value by bringing the
NCS pin high. After sending the register address, the
micro-controller must wait t
data. All data bits can be read with no delay between
bytes by driving SCLK at the normal rate. The data are
latched into the output buffer after the last address bit
is received. After the burst transmission is complete, the
micro-controller must raise the NCS line for at least t
to terminate burst mode. The serial port is not available
for use until it is reset with NCS, even for a second burst
transmission.
t
t
SWR
SWW
Write Operation
Data
Address
Next Read
Data
Operation
t
SRW
& t
Write Operation
SRR
Next Read or
SRAD
Address
and then begin reading
BEXIT