GT3F-1EAF20 IDEC, GT3F-1EAF20 Datasheet - Page 21

• Manufacturer Part Number: GT3F-1EAF20
• Description: GT3F-1EAF20 11 PIN SPDT TRUE POWER OFF DELAY TIMER
• Manufacturer: IDEC

Timers
Select the
time display and
operation modes.
Select the
single shot output
time.
Select a time range
that contains the
desired period of time.
Set the precise period of time desired by using the m Time Setting Digital Switch.
It is important to remember that the l Time Range Selector not only selects the time range but also infl uences the interpretation of the Digital Time Display.
Changing the l Time Range Selector setting changes the units of time measurement (seconds, minutes, hours) as well as the decimal point location.
Step 2
Step 3
Step 4
Step 1
ON-Delay One-Shot
Cycle One-Shot
ON-Delay One-Shot 2
0.01 seconds to 9.99 seconds
0.1 seconds to 99.9 seconds
1 second to 999 seconds
0.1 minutes to 99.9 minutes
1 minute to 999 minutes
0.1 hours to 99.9 hours
Operation Mode
Desired Mode of Operation
Desired Mode of Operation
j Indication Mode Selector
Timed OUT Indicator
Digital Time Display
(LCD backlit with red LED)
Desired Single-Shot
Desired Operation
Base Time Ranges
Desired Operation
1
Output Time
0.1 seconds
0.5 seconds
10 seconds
50 seconds
5 seconds
1 second
Time Display Mode
Time elapsed
Time remaining
Time elapsed
Time remaining
Time elapsed
Time remaining
1
Instructions: Setting GT3D-8 Timers
USA: 800-262-IDEC
Decimal Point
Indicator
j Indicator Mode Selector
l Time Range Selector
9.99
99.9
99.9
99.9
999
999
k Single-Shot Output
k Operation Mode Selector
A, B, C, D, E, F
Time Selector
Selection
Selection
Selection
Selection
1
1
2
2
3
3
A
D
B
C
E
F
Canada: 888-317-IDEC
Time Increment
Indicator
M
S
H
1. Use a fl at screwdriver to set the selectors. Since selectors do
not turn all the way around, both clockwise and counterclockwise
rotation is necessary.
2. The GT3D-8 j Indicator Mode Selector selects both whether the
Digital Time Display displays the time elapsed or time remaining
and also the mode of operation. Decide which display and mode is
desired. Then use this selector to set the operation mode.
On the GT3D-8 timers, the desired single-shot output time can be
selected from the A, B, C, D, E, and F modes using the k One-Shot
Output Time Selector.
1. The l Time Range Selector controls both the decimal point indi-
cator (9.99, 99.9, 999) and the time increment indicators S (seconds),
M (minutes), and H (hours).
2. Chose which base time range contains the targeted timer setting.
Then use the l Time Range Selector to set the decimal point indica-
tor and time increment indicator to its corresponding pair of settings.
3. Since these confi gurations offer a complete range of settings
from 0.01 seconds to 99.9 hours, the setting of 9.99 for minutes and
the 9.99 and 999 settings for hours are not listed and should not be
used.
Use the m Time Setting Digital Switch to set the desired period of
time. It is important to remember that the setting of the l Time
Range Selector determines the units of time measurement as well
as the implied decimal point location.
m Time Setting
l Time Range Selector
Digital Switch
9.99S – 99.9H
GT3D Series
Remarks
Remarks
Remarks
Remarks
825