HP2-DC24V PANASONIC EW, HP2-DC24V Datasheet - Page 13

• Manufacturer Part Number: HP2-DC24V
• Description: HP2 Relay (Plug-in)
• Manufacturer: PANASONIC EW

NOTES
1. There are two types of HP relay: plug-
in and direct mounting (HP2-TM and
HP3-M only).
Avoid use of direct mounting types in
sockets or terminal sockets.
Note: Mounting measurements for direct mounting
2. The terminals are compatible with tab
terminals. Consequently, for direct
mounting types, in addition to soldering,
AMP terminals can be used.
For Cautions for Use, see Relay Technical Information.
Part number
types (HP2-TM and HP3-M) are shown in the
drawing on page 146.
HP2
HP3
HP4
Compatible tab terminal
#205 series
#187 series
#205 series
All Rights Reserved © COPYRIGHT Matsushita Electric Works, Ltd.
3. When tightening the fixing screws of
direct mounting types, use washers to
prevent damage or distortion.
The optimum torque range is 0.49 to 0.69
N·m, (5 to 7 kgf·cm).
To prevent loosening of direct mounting
types, terminal sockets and sockets, etc.,
when fixing the screws, use spring
washers, etc. Moreover, wiring
(soldering), should be done with care
while ensuring strong connections.
4. When tightening terminal socket fixing
screws, to prevent damage, the optimum
torque range should be 0.784 to 0.98
N·m, (8 to 10 kgf·cm).
HP RELAY ACCESSORIES
5. Avoid use in adverse conditions, such
as where the relay will be subjected to
strong vibrations or shock, where there is
exposure to harmful gas, or where
ambient temperatures are high (more
than 40 C).
6. Use in DC load
Abnormal wear of the contacts and
contact springs will occur when the
switching frequency is high and there are
large arcs. In particular, if high-frequency
operation in hot or humid conditions is
intended, use arc-suppressing circuits.
7. There is no particular specification for
HP relay mounting orientation.
8. Do not insert or remove relays into or
out of live circuits.