CVM1-PA208 Omron, CVM1-PA208 Datasheet - Page 72
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
CVM1-PA208
Manufacturer Part Number
CVM1-PA208
Description
CV/CVM1 POWER SUPPLY, AC
Manufacturer
Omron
Datasheet
1.C500-OD501CN.pdf
(216 pages)
Specifications of CVM1-PA208
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 72 of 216
- Download datasheet (2Mb)
3-5
56
CPU and I/O Connecting Cables
CPU and I/O Connecting Cables
Note
The dimensions shown in the following diagram are required for the CPU and I/O
Connecting Cables when they are connected to the I/O Control Units and I/O
Interface Units. Be sure to allow sufficient space for the cables.
The total Connecting Cable length for any one series of Racks must be 50 m or
less. Plan installation locations and choose the Connecting Cables accordingly.
Do not place CPU or I/O Connecting Cables in the same duct as I/O power or
high-voltage lines.
Press in firmly on the connectors and be sure that the connectors on the CPU
and I/O Connecting Cables are locked into place on the I/O Control Unit and I/O
Interface Units. Bus errors, I/O setting errors, and other errors will occur if the
cables are not connected properly.
The connector lock and cable pull strength for the CPU Connecting Cables, I/O
Connecting Cables and Programming Device Cables are 5 kgf.
Always press in on the locks at the top and bottom of the connectors before re-
moving a cable connector.
Connect the CV500-TER01 Terminating Resistor Unit to the unused connectors
on the last I/O Interface Unit and to any unused connectors on the I/O Control
Unit. Two Terminating Resistor Units are provided with the CV500-IC101/IC201
I/O Control Unit.
1. The total Connecting Cable length for any one series of Racks must be 50 m
2. Press in firmly on the connectors until they lock into place.
3. Always press in on the locks at the top and bottom of the connectors before
or less.
removing a cable connector.
I/O Control Unit
Approx.
140 mm
I/O Interface Unit
Approx.
140 mm
Section
3-5
Related parts for CVM1-PA208
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![CVM1-FWL](/photos/9/32/93288/cvm1-fwl_tmb.jpg)
Part Number:
Description:
KIT UPGRADE FIRMWARE/LOGIC
Manufacturer:
TechTools
Datasheet:
![G6S-2G](/images/no-image3.png)
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
![G3NE-220T](/images/no-image3.png)
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
![G6K-2G-Y](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
![G4A-1A-E](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
![G5NB-1A-E](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
![G6B-2114P-US](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
![G6D-1A-ASI](/images/no-image3.png)
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: